著者

上田 隆司 花見 真司 平野 聡 山本 明

出版者

公益社団法人精密工学会

雑誌

精密機械 (ISSN:03743543)

巻号頁・発行日

vol.51, no.6, pp.1195-1200, 1985-06-05

被引用文献数

6

---

Influence of the bonding material of a diamond stick is investigated on honing performance. Three kinds of synthetic diamond sticks are used, that is, a metal bonded stick, a resinoid one and a vitrified one. For the metal bonded stick its bending strength is changed to find out the suitable bonding strength. Workpieces are alumina AI_2O_3,silicon nitride Si_3N_4 and silicon carbide SiC, which are sintered under atmospheric pressure. The results are as follows. The metal bonded diamond stick is most suitable for the effective honing of these three ceramics. In this stick, there is an advisable value of bending strength σ_b to get high productivity, namely, 120-140 MPa for AI_2O_3 and 80-100 MPa for Si_3N_4 and SiC honing, and these are less than the ordinary value 200 MPa at metal honing. This comes from necessity of creating some new cutting edges in operating. Then, the diamond grain with high toughness is recommended. Using the vitrified bonded stick and the cubic boron nitride grain is not advisable.