著者

飯田 明由 小久保 あゆみ 塚本 裕一 本田 拓 横山 博史 貴島 敬 加藤 千幸

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 B編 (ISSN:03875016)

巻号頁・発行日

vol.73, no.732, pp.1637-1646, 2007-08-25 (Released:2011-03-03)

参考文献数

10

被引用文献数

4 1 7

---

The aim of this investigation is to understand the generation mechanism of aero-acoustic feedback noise radiated from rear-view mirrors. In order to clarify the relationship between the velocity fluctuation and radiated noise, correlation in terms of aerodynamic noise and velocity fluctuations were measured in a low-noise wind tunnel. The experimental results showed that noise level of the tonal-noise depended on the ratio of the height of the bump to the thickness of the boundary layer. Strong tonal-noise was generated when the height of the bump was almost equal to 40% of the height of the boundary layer. The tonal-noise level also depended on the length between the trailing-edge of the bump and the edge of rear-view mirror. The frequency of the tonal noise can be calculated by modified Rossiter equation. The tonal-noise was disappeared in the case of the bump was placed at separated boundary layer. It revealed that the seed of the tonal noise was small disturbances generated by the bump on the surface of the rear-view mirror.

著者

飯田 明由 小久保 あゆみ 塚本 裕一 本田 拓 横山 博史 貴島 敬 加藤 千幸

出版者

一般社団法人日本機械学会

雑誌

日本機械学會論文集. B編 (ISSN:03875016)

巻号頁・発行日

vol.73, no.732, pp.1637-1646, 2007-08-25

被引用文献数

6

---

The aim of this investigation is to understand the generation mechanism of aero-acoustic feedback noise radiated from rear-view mirrors. In order to clarify the relationship between the velocity fluctuation and radiated noise, correlation in terms of aerodynamic noise and velocity fluctuations were measured in a low-noise wind tunnel. The experimental results showed that noise level of the tonal-noise depended on the ratio of the height of the bump to the thickness of the boundary layer. Strong tonal-noise was generated when the height of the bump was almost equal to 40% of the height of the boundary layer. The tonal-noise level also depended on the length between the trailing-edge of the bump and the edge of rear-view mirror. The frequency of the tonal noise can be calculated by modified Rossiter equation. The tonal-noise was disappeared in the case of the bump was placed at separated boundary layer. It revealed that the seed of the tonal noise was small disturbances generated by the bump on the surface of the rear-view mirror.