著者

橋村 真治 小松 恭一 大津 健史 関戸 裕二郎

出版者

一般社団法人 日本トライボロジー学会

雑誌

トライボロジスト (ISSN:09151168)

巻号頁・発行日

vol.62, no.3, pp.205-216, 2017-03-15 (Released:2017-03-16)

参考文献数

12

---

In recent years, self-loosening detail mechanisms of bolted joints had been revealed using three dimensional FE analysis in which the bolts and the nuts have almost perfect configurations geometrically. However the configurations of actual bolts and nuts have certainly errors. Wear on contact surfaces also occurs in the actual bolted joint. Hence it is not easy to accurately simulate the actual bolted joint by only FEM. In this study, an influence of lubricants on self-loosening characteristics have been investigated in order to understand actual phenomena in self-loosening process. The self-loosening tests for a hexagon head cap screw M10 due to transverse vibration were performed under lubricated conditions by Machine oil ISO VG46, Molybdenum disulfide grease and Polyisobuthylene which is used as a special lubricant for bolt tightening. A bearing surface configuration of the bolt was controlled in this study. The results showed that the bolted joints lubricated by Polyisobuthylene had a higher resistance for self-loosening than the bolted joints lubricated by Molybdenum disulfide grease and Machine oil ISO VG46. The number of cycle until loosening depended on bearing surface configurations.