著者

Hiroshi OKAJIMA Tatsuya UMEMOTO Nobutomo MATSUNAGA Shigeyasu KAWAJI

出版者

The Society of Instrument and Control Engineers

雑誌

Transactions of the Society of Instrument and Control Engineers (ISSN:04534654)

巻号頁・発行日

vol.46, no.3, pp.149-156, 2010 (Released:2011-11-03)

参考文献数

16

被引用文献数

5 4

---

It is well known that plants with time delay are hard to be controlled by using traditional method. For this, controller with delay, such as Internal Model Control (IMC), Smith-method, have been proposed for input-delay systems. However, it would be difficult to realize the delay of controller because of memory limit of micro control unit(MCU). Also, the sampling time might be large in case of the application to the plant with large time delay, because of the limitation of the memory in MCU. Hence, the trade-off exists between sampling time and maximum quantizing error, and the assignment of the quantizer affects the quantization error. In this paper, dynamic quantizers are designed for achieving small quantizing error for input-delay control systems in MCU system. Also, the attainable performance caused by assignment of the quantizer is discussed. The effectiveness of the proposed method is shown by numerical example.

著者

Hiroshi OKAJIMA Nobutomo MATSUNAGA Shigeyasu KAWAJI

出版者

The Society of Instrument and Control Engineers

雑誌

Transactions of the Society of Instrument and Control Engineers (ISSN:04534654)

巻号頁・発行日

vol.44, no.5, pp.458-460, 2008-05-31 (Released:2013-02-25)

参考文献数

4

被引用文献数

2 3

---

This paper is concerned with dynamic quantizer for controlling plants with discrete-valued input.l∞ norm of error between outputs with continuous-input and with quantized-input was guaranteed by the quantizer proposed by Azuma et al. In this paper, the degree of freedom of quantizer, which also guarantees the l∞ norm, is considered for treating the other objectives such as robustness, reduced-order controller etc. Then a design method of reduced-order quantizer is proposed by using the design parameter. The effectiveness of reduced-order quantizer is shown by numerical examples.

著者

Hiroshi OKAJIMA Toru ASAI Shigeyasu KAWAJI

出版者

The Society of Instrument and Control Engineers

雑誌

Transactions of the Society of Instrument and Control Engineers (ISSN:04534654)

巻号頁・発行日

vol.45, no.6, pp.313-319, 2009 (Released:2011-11-03)

参考文献数

18

---

In this paper, tracking performance limitations for plants with input delay are considered. It is important to know the performance limitations for plants to design controllers and to design plants. Our objective is to find the fundamental limitation of the transient response in tracking control problem. When plant have input delay, no one would deny that tracking performance becomes worse than the plants without input delay. However performance limitations for such plants have not been derived analytically. We derive the performance limitations based on internal model control framework. The difference between plants with delay and without delay is compared by numerical examples.

著者

Hiroshi OKAJIMA Toru ASAI Shigeyasu KAWAJI

出版者

The Society of Instrument and Control Engineers

雑誌

Transactions of the Society of Instrument and Control Engineers (ISSN:04534654)

巻号頁・発行日

vol.44, no.10, pp.793-801, 2008-10-31 (Released:2013-02-25)

参考文献数

19

被引用文献数

1 1

---

This paper is concerned with optimal reference tracking control problem for discrete time 1-DOF/2-DOF systems. It is well known that l2 norm of an error, which is defined by difference between an output and a reference, does not turn zero for all possible controllers when plant is given as a non-minimum phase system. Purpose of this research is to derive closed-form expression of the optimal value of l2 norm of the error and its controller. The references for tracking are e.g. step, sine, impulse train, triangle wave and linear combination of these signals. Therefore, we can handle various signals as a reference. Moreover, our results can also characterize impact of the relative degree of plant. Those effectiveness are shown by numerical examples.