著者

KOYUTURK Alp Erdin AKCA Taner YUCEL Ali Cagin YESILYURT Cemal

出版者

日本歯科理工学会

雑誌

Dental materials journal (ISSN:02874547)

巻号頁・発行日

vol.25, no.4, pp.713-718, 2006-12-01

参考文献数

39

被引用文献数

2 7

---

The purpose of this study was to examine the effect of thermal cycling on microleakage of a fissure sealant after it was bonded with different bonding agents and polymerized with different light curing units. To this end, two bonding agents (Xeno III, iBond), three light curing units (Astralis 3, Elipar free-light, Elipar free-light 2), and a fissure sealant (Fissurit FX) were used. Microleakage was then evaluated using a dye penetration method after thermal cycling. When the fissure sealant was polymerized with Elipar free-light and Elipar free-light 2, microleakage at 10,000 cycles was significantly increased compared with that at 5,000 cycles. In terms of comparison among the curing units, the best microleakage score was observed with Astralis 3 (p<0.05). In terms of comparison between the two bonding agents, no significant differences in microleakage score were observed (p>0.05). Further, it was concluded that in order to evaluate microleakage scores appropriately, it was necessary for specimens to be subjected to thermocycling of 10,000 times or more.