著者

山田 隆一 柳 和久 リ チウィ

出版者

公益社団法人精密工学会

雑誌

精密工学会誌 (ISSN:09120289)

巻号頁・発行日

vol.64, no.12, pp.1785-1790, 1998-12-05

被引用文献数

2 1

---

As the machine tools are shifting to high precision cutting, it is necessary to develop an effective instrumentation system and to establish an evaluation method for the spindle run-out error. In this paper, a new measurement system for the run-out error was developed by utilizing an transmitted light beam method. Also a new evaluation method was established by separating the run-out error into rotational error and tool chucking error. The measuring principle is based upon edge detection technique in which a halved photo detector is used to quantify the amount of the transmitted light through the both sides of the pin-gauge used as a master specimen. By providing two similar optical setups which are placed perpendicular to the rotating axis of the pin-gauge, an X-Y displacement measurement system of the pin-gauge was built up. The run-out error of the spindle can be known directly by evaluating the displacement of the pin-gauge through its Lissajous figure. Finally, it was clarified that the performance of the developed evaluation system is practically acceptable.