著者

増尾 竜一 前田 親良 田口 太一郎

出版者

公益社団法人 計測自動制御学会

雑誌

計測と制御 (ISSN:04534662)

巻号頁・発行日

vol.2, no.8, pp.607-616, 1963-08-10 (Released:2010-10-21)

参考文献数

12

---

It is generally believed that an accuracy of a balance utilizing a spring is deteriorated by the influence hysteresis. This paper intends to make it clear that a balance using a spring, if observed independent the principle of measurement, will come under a major influence of hysteresis when measurement made under a balance effected between the gravity and elasticity, while it will be little affected hysteresis if a spring is used as a lever fulcrum and measurement is made under a balance with standard weight. In the latter case, the main cause for dispersion in the case of knife-edge fulcrum is removed with the result that the dispersion may be minimized. Then, various constructions of the fulcrum which a lever is hung by the spring were classified and thus, their respective superiority or inferiority fulcrum in respect to sensitivity and load standing capacity was examined. As the result, an fulcrum of cross flexure was found to be superior because it fully satisfies all of these conditions required. Accordingly, a pendulum balance using such a fulcrum was experimentally manufactured with an application of the Roberval mechanism. Its dispersion, as anticipated, is far less than that of conventional balance using the knife-edge fulcrum.