著者

仙波 浩雅 岡部 永年 山地 徹 沖田 圭介 山内 清 松本 賢哉

出版者

一般社団法人日本機械学会

雑誌

日本機械学会論文集 A編 (ISSN:03875008)

巻号頁・発行日

vol.71, no.709, pp.1234-1242, 2005

被引用文献数

1

---

This paper deals with the bulge process for forming the single-stage bellows of TiNi shape memory alloys, which is proposed as a new type of seismic applications, and especially considering the material's special behavior. Thin walled tubes with 20% cold work, whose composition is Ti51.0 at% Ni, were prepared. First they are appropriately heat-treated and then the rubber bulge process is introduced for the tubes under the condition of austenite phase at room temperature. Displacement control method is adapted to the process. Theoretical prediction of change in outer diameter of the tube on compression is derived, and modified taking into account the progress of the stress-induced martensite transformation on tube's surface by observing the detachment of the oxide layer of the surface. Finally theoretical relationship between compressive displacement and the outer diameter of the tube, which is the most inportant for the design of the bellows shape, is cleared.