著者

福田 理明 笹原 弘之 松田 礼 堤 正臣

出版者

公益社団法人 精密工学会

雑誌

精密工学会誌 (ISSN:09120289)

巻号頁・発行日

vol.76, no.1, pp.111-115, 2010-01-05 (Released:2010-07-05)

参考文献数

7

被引用文献数

1 1

---

This study describes a new machining strategy to make regularly aligned geometric pattern by ball-end milling process employing a patch division milling technique. The surface is divided into a lot of triangle patch segments which is machined with helical tool path. It is newly proposed the way to array cutter marks straightly in arbitrary triangle patches. In addition, it is shown that the inclination angle of cutter marks array against the feed direction can be controlled by the appropriate setting of feed per tooth and cross feed for an arbitrary triangle patch. It is shown that the experimental results and simulation results are in good agreement. It is also reported that the well arranged cutter marks arrays are formed on the triangle patches on the spherical model.

著者

大井 星十 田井 貴 町田 信夫 松田 礼

出版者

一般社団法人 日本人間工学会

雑誌

日本人間工学会大会講演集 日本人間工学会第53回大会

巻号頁・発行日

pp.146-147, 2012 (Released:2012-10-27)