1 0 0 0 OA 233 高Mn非磁性鋼と炭素鋼との異材溶接継手の疲労強度
1 0 0 0 OA 高Mn非磁性鋼と炭素鋼との溶接継手の継手特性と疲労強度
- 著者
- 中地 映司 池田 惣一 金 裕哲 中辻 義弘 堀川 浩甫
- 出版者
- 社団法人溶接学会
- 雑誌
- 溶接学会論文集 : quarterly journal of the Japan Welding Society (ISSN:02884771)
- 巻号頁・発行日
- vol.15, no.3, pp.535-540, 1997-08-05
- 参考文献数
- 7
The dissimilar materials welded joints of high manganese non-magnetic steel/carbon steel(hereafter refered to as DMW joints), in which weld defects such as hot crack or blowhole are not found, were the good quality. Tensile strength of DMW joints was 10% higher than that of the base metal of carbon steel. In the bend tests, the DMW joints showed the good ductility without crack. Charpy absorved energy at 0 (℃) of the DMW joints was over 120 (J) in the bond where it seems to be the lowest. Large hardening or softening was not detected in the heat affected zone. Fatigue strength of the DMW joints is almost the same with that of the welded joints of carbon steel/carbon steel. As the fatigue strength of the DMW joints exceeds the fatigue design standard curve of JSSC for carbon steel welded joints, the DMW joints can be treated the same as the welded joints of carbon steel/carbon steel of which strength is lower than that of high manganese non-magnetic steel, from the viewpoint of the fatigue design.