著者

高野 和友 木股 文昭

出版者

SEISMOLOGICAL SOCIETY OF JAPAN

雑誌

地震 第2輯 (ISSN:00371114)

巻号頁・発行日

vol.62, no.2+3, pp.85-96, 2009-12-25 (Released:2012-03-26)

参考文献数

44

被引用文献数

1

---

This study reexamines the ground deformation and fault slip model of the 1945 Mikawa earthquake (M =6.8), central Japan. We reevaluate two geodetic data sets from the years 1886/1887 and 1955/56 that were obtained from the Geographical Survey Institute; these data sets consist of displacements calculated from the net adjustment of triangulation surveys carried out before and after the Mikawa earthquake. We remove the interseismic deformation and coseismic deformation of the 1944 Tonankai earthquake from the two unique data sets used in our analysis. Maximum coseismic horizontal displacements of over 1.4 m were detected to the west of the Fukozu fault. We estimated the coseismic slip by analyzing our data set. The geometry of the fault planes was adopted from a recent seismicity study and from the surface earthquake fault of this area. The best fit to the data is obtained from two faults along the sections running north and south of the Fukozu and Yokosuka faults. The estimated uniform-slip elastic dislocation model consists of two adjacent planes. The fault also appeared to connect the sections running north and south of the Fukozu and Yokosuka faults. Because it can suitably explain the coseismic deformation due to two earthquake source faults, the earthquake source fault is not admitted under the section for the run. The mechanism is considered to be two reverse faults with right-lateral components. The estimated slips for the two source faults are 2.5 m and 1.4 m, respectively. The pressure axis is directed along NE-SW or E-W. The total seismic moment determined from this model is 1.6 × 1019 Nm, corresponding to Mw=6.7.

著者

高野 和友 木股 文昭

出版者

公益社団法人 日本地震学会

雑誌

地震 第2輯 (ISSN:00371114)

巻号頁・発行日

vol.62, no.2, pp.85-96, 2009

被引用文献数

1

---

This study reexamines the ground deformation and fault slip model of the 1945 Mikawa earthquake (<I>M</I> =6.8), central Japan. We reevaluate two geodetic data sets from the years 1886/1887 and 1955/56 that were obtained from the Geographical Survey Institute; these data sets consist of displacements calculated from the net adjustment of triangulation surveys carried out before and after the Mikawa earthquake. We remove the interseismic deformation and coseismic deformation of the 1944 Tonankai earthquake from the two unique data sets used in our analysis. Maximum coseismic horizontal displacements of over 1.4 m were detected to the west of the Fukozu fault. We estimated the coseismic slip by analyzing our data set. The geometry of the fault planes was adopted from a recent seismicity study and from the surface earthquake fault of this area. The best fit to the data is obtained from two faults along the sections running north and south of the Fukozu and Yokosuka faults. The estimated uniform-slip elastic dislocation model consists of two adjacent planes. The fault also appeared to connect the sections running north and south of the Fukozu and Yokosuka faults. Because it can suitably explain the coseismic deformation due to two earthquake source faults, the earthquake source fault is not admitted under the section for the run. The mechanism is considered to be two reverse faults with right-lateral components. The estimated slips for the two source faults are 2.5 m and 1.4 m, respectively. The pressure axis is directed along NE-SW or E-W. The total seismic moment determined from this model is 1.6 &times; 10<SUP>19</SUP> Nm, corresponding to <I>M</I><SUB>w</SUB>=6.7.