- 著者
-
NAKA Sachiko
AOYAMA Eiichi
HIROGAKI Toshiki
ONCHI Yoshiaki
OGAWA Keiji
OKU Kentaro
- 出版者
- 一般社団法人日本機械学会
- 雑誌
- Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
- 巻号頁・発行日
- vol.2005, no.3, pp.1187-1192, 2005-10-18
We have developed a new ultra-low pressure method for obtaining a finer finish in super-finishing using vitrified bonded cubic boron nitride (cBN) abrasive stones, recommended for use in the burnishing stage. This is a finer finish with very small or no stock removal, than ordinarily occurs in a conventional process using aluminum oxide or silicon carbide stones. We have fabricated a prototype super-finishing machine that provides stable ultra-low pressures using an air slider. Super-finishing was attempted using ultra-low pressures (less than 0.1MPa) with cBN abrasives averaging less than 8μm in diameter. As a result, super-finishing with a processing pressure of 0.02MPa could be achieved using fine-grit cBN. The study demonstrated that it is possible to obtain a surface finish on the nano-order under ultra-low pressure conditions.