- 著者
- Ji-Hyun JANG Myoung Geun LEE Sang Uk WOO Chung Ok LEE Jin-Kyu YI Duck-Su KIM
- 出版者
- The Japanese Society for Dental Materials and Devices
- 雑誌
- Dental Materials Journal (ISSN:02874547)
- 巻号頁・発行日
- vol.35, no.4, pp.606-612, 2016-07-29 (Released:2016-07-30)
- 参考文献数
- 33
- 被引用文献数
- 33 34
This study compared the dentin bond strength of a new universal adhesive with that of contemporary multi-step dentin adhesives. Six experimental groups were prepared according to the adhesives used and their application modes: Optibond FL (OB), Adper Single Bond Plus (SB), One-Step Plus (OS), Clearfil SE Bond (CS), All-Bond Universal using etch-and-rinse mode (ABE), and AllBond Universal using self-etch mode (ABS). Micro-tensile bond strength (µTBS) and failure mode were evaluated for each group. The bonded interface was analyzed using transmission electron microscopy (TEM). As a result, µTBS of 6 experimental groups was followed as: OB=ABE=SE=ABS>SB>OS group. TEM micrographs of ABE and ABS groups revealed a homogenous adhesive layer formation. In conclusion, a new universal adhesive can make reliable bond to dentin, regardless of the application mode.
- 著者
- Duck-Su KIM Sang Hyuk PARK Gi-Woon CHOI Kyoung-Kyu CHOI Sun-Young KIM
- 出版者
- The Japanese Society for Dental Materials and Devices
- 雑誌
- Dental Materials Journal (ISSN:02874547)
- 巻号頁・発行日
- vol.30, no.5, pp.717-722, 2011 (Released:2011-10-08)
- 参考文献数
- 26
- 被引用文献数
- 12 14
The effect of the ethylenediaminetetraacetic acid (EDTA) treatment on the hybrid layer durability of total-etch dentin adhesives was investigated. A flat dentin surface was exposed and treated with 37% phosphoric acid or 0.1M EDTA. Dentin adhesive was applied and a 4 mm thick composite resin was built-up. Twenty 0.9×0.9 mm2 resin-dentin beams were fabricated in each experimental group. Artificial aging with 10% NaClO was performed in half of the experimental groups for 1 hour. A micro-tensile bond strength (μTBS) test was performed and the bonded interface was analyzed with transmission electron microscopy (TEM). The 37% phosphoric acid-treated group showed a lower μTBS after artificial aging, whereas the 0.1M EDTA-treated group did not. TEM analysis revealed collagen fibrils dissolved in the 37% phosphoric acid-treated group but not in the 0.1M EDTA-treated group. Undissolved minerals were observed in the 0.1M EDTA-treated group. In conclusion, a dentin treatment with 0.1M EDTA is effective in improving the hybrid layer durability.