- 著者
- Aye KO KO Naoko MATSUI Ayako NAKAMOTO Masaomi IKEDA Toru NIKAIDO Michael F. BURROW Junji TAGAMI
- 出版者
- The Japanese Society for Dental Materials and Devices
- 雑誌
- Dental Materials Journal (ISSN:02874547)
- 巻号頁・発行日
- vol.39, no.3, pp.407-414, 2020-05-27 (Released:2020-06-05)
- 参考文献数
- 32
- 被引用文献数
- 11 16
The purpose of this study was to evaluate the effects of two different concentrations of silver diammine fluoride (SDF) on dentin bonding performance. Human mid-coronal dentin was treated with either distilled water (control), 3.8%SDF or 38%SDF for 3 min. A two-step self-etch adhesive and resin composite were applied according to manufacturer’s instructions. After thermocycling (TC) at 0, 5,000 and 10,000 cycles, microtensile bond strength (µTBS) testing and morphological assessment of resin-dentin bonding interface were performed. At 0 TC, µTBSs of 3.8% and 38%SDF were significantly reduced (p<0.05). At 5,000 and 10,000 TC, µTBSs of 3.8%SDF were comparable to those of the control group, whereas the µTBSs of 38%SDF were significantly lower (p<0.05). Acid-base resistance zone formation was observed in all groups, however, slope-shaped formation was identified only in the SDF groups. The µTBSs and interfacial morphology were influenced by concentration of SDF and also TC.
- 著者
- Toru NIKAIDO Tomohiro TAKAGAKI Takaaki SATO Michael F. BURROW Junji TAGAMI
- 出版者
- The Japanese Society for Dental Materials and Devices
- 雑誌
- Dental Materials Journal (ISSN:02874547)
- 巻号頁・発行日
- pp.2020-165, (Released:2020-07-04)
- 参考文献数
- 40
- 被引用文献数
- 3 9
Self-etch adhesive (SEA) systems simplify bonding procedures. It is believed that good mechanical retention and chemical bonding are both important factors to obtain reliable bonding to enamel. The enamel acid-base resistant zone (ABRZ) has been confirmed at the adhesive/enamel interface by scanning electron microscopic observation. However, the formation of enamel ABRZ is influenced by the type and components of adhesive systems. Chemical interactions by a functional monomer with hydroxyapatite strongly support the explanation of the mechanism for enamel ABRZ formation. The ABRZ created by MDP-containing SEA systems has shown good potential to resist acid attack from simulated recurrent caries models. In addition, fluoride release may enhance acid resistance. It has been proposed that such a reinforced enamel be termed “Super Enamel”. The concept of the formation of super enamel may contribute to protecting enamel, and conserve tooth structure leading to improved restoration longevity.
- 著者
- Nobutaka AKAZAWA Hiroyasu KOIZUMI Hiroshi NOGAWA Akihisa KODAIRA Michael F. BURROW Hideo MATSUMURA
- 出版者
- The Japanese Society for Dental Materials and Devices
- 雑誌
- Dental Materials Journal (ISSN:02874547)
- 巻号頁・発行日
- pp.2018-152, (Released:2019-05-09)
- 参考文献数
- 28
- 被引用文献数
- 8
The purpose of the current study was to evaluate the effect of etching with potassium hydrogen difluoride (KHF2) and ammonium hydrogen difluoride (NH4HF2) on the bond strength of a self-polymerizing methyl methacrylate resin (MMA-TBB) bonded to zirconia. Zirconia disks were prepared using the following surface treatment: no treatment, alumina blasting, and etching with KHF2 or NH4HF2. The specimens were bonded with the MMA-TBB. The shear bond (Ø=5 mm) strength was measured. The surface free energies of the specimens were determined by measuring contact angles. The KHF2 and NH4HF2 groups exhibited higher shear bond strength and surface free energy than did the alumina blasting and no treatment groups. Compared with alumina blasting, etching with KHF2 and NH4HF2 exhibited superior bonding ability of mechanical retention to zirconia.