- 著者
-
Xiaodong DENG
Mengtian RONG
Tao LIU
- 出版者
- The Institute of Electronics, Information and Communication Engineers
- 雑誌
- IEICE TRANSACTIONS on Communications (ISSN:09168516)
- 巻号頁・発行日
- vol.E95-B, no.1, pp.152-159, 2012-01-01
Large capacity tags are becoming available to meet the demands of industry, but the UHF RFID protocol is unable to reliably and efficiently read large data sets from tags. First of all, large data sets are not well protected. The tag merely relies on 16-bit CRC for ensuring the validity of up to 4,096-bit user-specific data in EPCglobal C1G2 protocol. Furthermore, the reliability will be even worse if large capacity tags are implemented using semi-active technology which is likely to prevail among sensor-integrated RFID tags. Since semi-active tags greatly alleviate the performance limitation imposed by the turn-on power of the tag chip, backscattering signal of semi-active tags could be a serious challenge for most readers because it is much weaker than signals emitted by passive tags due to longer reading distance. In this paper, Interim CRC is presented to enhance transmission reliability and efficiency when the tag is backscattering a large data set. By taking advantage of Interim CRC, the large data set can be divided into several blocks, and 16-bit checksum is calculated over each block. The tag backscatters all blocks at the first time and only retransmits certain blocks if CRC error occurs in those blocks. The result of simulation shows that the reading error rate can be confined to a preset threshold and the accumulative total of transmitted data are greatly reduced if optimal block size and transmission times are complied with. The simulation also conclusively proves that semi-active tags derive even longer reading range from Interim CRC. In addition, Interim CRC is totally compliant with the EPCglobal C1G2 protocol. It fully makes use of CRC-16 encoder and does not involve any other data encoding schematics and hardware modifications.