著者
神田 康行
出版者
一般社団法人 日本機械学会
雑誌
日本機械学会論文集
巻号頁・発行日
2019
被引用文献数
1

<p>The rigid plastic finite element method (RPFEM) is used in many re-meshing procedures in material processing analysis. Currently, the four-node quadrilateral element, which can avoid volumetric locking, is applied in the RPFEM. However, it is desirable to apply the three-node triangular element instead because of its easy and robust mesh generation procedure. This study applied the three-node triangular element with drilling and strain degrees of freedoms (GNTri3) to the RPFEM, the validity of which was verified by analyzing some numerical examples. First, as verification for the volumetric locking characteristic of the GNTri3, FEM analysis of a nearly incompressible elastic body under plane strain conditions was performed. Volumetric locking was recognized by applying full integration to the element stiffness matrix of the GNTri3. Therefore, it was revealed that the RPFEM using the GNTri3 is necessary for applying selective reduced integration to the element stiffness matrix. Analysis of the RPFEM using the GNTri3 showed that the tool pressure was in good agreement with theoretical solutions and FEM results obtained using a conventional four-node quadrilateral element at a rigid punch indentation. In addition, reasonable material processing deformations were computed in the plane strain compression test.Therefore, validity of the RPFEM using the GNTri3 was verified by numerical results.</p>

言及状況

外部データベース (DOI)

Twitter (1 users, 1 posts, 0 favorites)

回転とひずみ自由度を有する三節点三角形要素の剛塑性有限要素法への適用とその有効性の検討 : https://t.co/FmRlQLUjpi

収集済み URL リスト