著者

加藤 秀治 伊藤 江平 北村 明大 池永 訓昭 久保田 和幸

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.855, pp.17-00258-17-00258, 2017 (Released:2017-11-25)

参考文献数

12

被引用文献数

1

---

Recently, a titanium alloy has been as biomaterials that have stable mechanical property and superior biocompatibility. But the titanium alloy generally has higher young’s modulus in comparison with cortical bone, then bone resorption was occurred by stress shielding. For this reason β-type titanium alloy exhibiting super-elasticity and super-plasticity was developed. This alloy has high tensile stress and low young’s modulus too. However, the characteristics of this alloy is lost by severe heat environment and external force. Therefore, there is possibility that the advantageous characteristics may be lost during cutting. In this study, the effect of cutting temperature and cutting force on the affected layer was investigated by milling with small ball end mill tool in order to decrease the affected layer by cutting process. At the cutting speed of 16.0m/s, the thickness of the affected layer exceeded 2.5μm because of increasing of cutting temperature that approached to the neighborhood of transition temperature of this alloy. On the other hand, the affected layer was observed for the cutting condition of high cutting force by increasing feed rate of a tooth, depth of cut and pick feed, the thickness of the affected layer was 0.7μm .So, the affected layer was dominant by the influence of cutting temperature. To decreasing affected layer, the cutting temperature is able to decrease to decreasing feed rate of a tooth or depth of cut.