著者

熊本 和宏 國友 美信 岸本 章宏 岡本 克文 倉満 晶子 宇田 哲也

出版者

一般社団法人 資源・素材学会

雑誌

Journal of MMIJ (ISSN:18816118)

巻号頁・発行日

vol.137, no.1, pp.10-16, 2021-01-31 (Released:2021-01-29)

参考文献数

31

---

A new Ti smelting process via. Bi–Ti alloy is proposed. This process comprises reduction of TiCl4 to Bi–10 mol%Ti alloy by Bi–Mg alloy, precipitation of Ti-rich compound from the alloy, and vacuum distillation. In this study, we investigated the precipitation and distillation processes. In the precipitation process, the Bi–10 mol%Ti liquid alloy is cooled from 900 ℃ to 500 ℃ to precipitate Bi9Ti8 in the liquid alloy. The Bi9Ti8 is recovered by a two-step separation method: recovery of mixture of Bi9Ti8 and Bi and further removal of Bi by centrifugal filtration. We demonstrated the recovery of mixture. As the results, Ti concentration in the mixture was 31 mol%, and the Ti yield was about 45 %. Because the remained liquid alloy after the recovery contains a large amount of Bi9Ti8, it is required to reuse the remained alloy in the precipitation process. Assuming the reuse of remained alloy, the material flow of the process was designed based on the experimental results. The centrifugal filtration of the mixture of Bi9Ti8 and Bi was also carried out at 500 ℃. By the centrifugal filtration at 50 G, alloys with a size of 1.5 mm were obtained, and the Ti concentration in the alloys was increased from 31 mol% to 40 mol%. Vacuum distillation of alloy powder and ingot was demonstrated. The distillation rate was enhanced when using the powder than when using alloy ingot as a starting material.