著者

鴨下 隆志 広瀬 武範 中村 哲夫 矢野 宏

出版者

一般社団法人 品質工学会

雑誌

品質工学 (ISSN:2189633X)

巻号頁・発行日

vol.4, no.2, pp.49-57, 1996-04-01 (Released:2016-03-24)

参考文献数

7

被引用文献数

2

---

In order to study the calibrating method and the error after calibration for a measuring system, the method to determine the dimensional measuring error of a component part through experimentation was discussed. The procedures of this method followed the guidelines described in JIS Z9090, measurement-General rules for calibration system, a standard established based on the concepts of quality engineering. The calibration was conducted by such new concepts. Up to present, the determination of measurement error has been ambiguous. But from this study, it was concluded that error can be rationally determined by one of the three practical cases of picking up the sources of error. lt is also stated in this paper that quality engineering approaches can be applied to determine the expanded uncertainty which is included in ISO Guide of the Expression of Uncertainty in Measurement.