著者

星野 純輝 祖山 均

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.849, pp.16-00502-16-00502, 2017 (Released:2017-05-25)

参考文献数

10

---

In order to establish a new approach to manufacturing of CaCO3 which can be adapted to structural materials, the formation of CaCO3 using continuous-wave laser has been conducted on austenitic stainless steel JIS SUS316L surface. It has been demonstrated that localized heating by laser irradiation could control the formation. CaCO3 was obtained from heating Ca(HCO3)2. The film thickness of CaCO3 formed at various conditions was measured, therefore it was revealed the effect of various factors on the formation of CaCO3. The higher laser power P, the thicker the film thickness of CaCO3, however, high laser power (1.5 W) decreases the film thickness when laser irradiation is continued for many hours. Changing the distance from condenser lens d to specimen, it can control the film thickness and the width of CaCO3 film without increasing energy. When the velocity of specimen v is 1.0 mm/s, the film thickness is the highest among other velocities and the shape of CaCO3 film is clear. The temperature of Ca(HCO3)2 Tw have not much effect on the film thickness, although the temperature have effect on the width of CaCO3 film. Therefore, CaCO3 film can be formed efficiently by controlling the factors such as laser power. The optimum condition of fabrication of CaCO3 which we inferred from these results was P = 1.0 W, d = 30 mm, v = 0.1 mm/s, Tw = 45 °C, laser irradiation time t = 5 h. This manufacturing have probability to be able to fabricate the structure of CaCO3 flexibly.