著者
竹ノ内 敏一 片桐 広子 岩野 恵子 中村 敦子
出版者
一般社団法人 表面技術協会
雑誌
表面技術 (ISSN:09151869)
巻号頁・発行日
vol.61, no.9, pp.658, 2010-09-01 (Released:2011-03-25)
参考文献数
13
被引用文献数
2 1

The authors, using sodium hypochlorite solution, hydrochloric acid, and sodium chloride, prepared acidic synthesized water having the same characteristics and composition as an anodically electrolyzed sodium chloride solution (acidic electrolyzed water). The following findings were obtained by investigating the characteristics of each solution and the dissolution behavior of copper. 1) The dissolved oxygen concentration and free chlorine concentration decrease immediately after electrolysis in acidic electrolyzed water. Their rates of decline are higher than in acidic synthesized water. 2) The dissolution rate and surface morphology of copper immersed in the respective solutions are almost identical. 3) Free chlorine in these solutions accelerates the dissolution rate. The dissolved chlorine increases the surface roughness of copper. 4) Oxygen nanobubbles probably exist much in acidic electrolyzed water. 5) Dissolution behavior of copper immersed in acidic electrolyzed water differs between during electrolysis and after electrolysis. Dissolution rate of copper is larger, and surface was not roughened in acidic electrolyzed water during electrolysis. These phenomena are presumably attributable to the actions of hydroxyl radicals generated during electrolysis.