著者
増村 拓朗 谷口 大河 浦中 祥平 平嶋 一誠 土山 聡宏 丸山 直紀 白幡 浩幸 植森 龍治
出版者
一般社団法人 日本鉄鋼協会
雑誌
鉄と鋼 (ISSN:00211575)
巻号頁・発行日
vol.106, no.11, pp.835-843, 2020 (Released:2020-10-31)
参考文献数
22
被引用文献数
1 7

Electrical resistivity of low-carbon martensitic steels was measured to estimate the carbon concentration in solid solution. Since electrical resistivity is influenced not only by solute carbon but also by substitutional elements, lattice defects and second phase, the effects of these factors need to be subtracted from total electrical resistivity, in order to obtain the accurate solute carbon concentration by this method. As a result, the effects of dislocations and grain boundaries were much smaller than that of solute elements, being only 1 - 2% of the measured electrical resistivity, in martensitic steel. On the other hand, substitutional elements and retained austenite were found to be significantly effective. By subtracting these effects from the measured value, the change in electrical resistivity due to solute carbon, Δρsol.C, could be formulated as a function of the carbon concentration in solid solution of martensite, Csol, as follows:Δρsol.C [mΩmm] = 0.25 × Csol [mass%]The estimated solute carbon concentration was confirmed to correspond to the directly measured value by atom probe tomography.
著者
前野 圭輝 田中 將己 吉村 信幸 白幡 浩幸 潮田 浩作 東田 賢二
出版者
一般社団法人 日本鉄鋼協会
雑誌
鉄と鋼 (ISSN:00211575)
巻号頁・発行日
vol.98, no.12, pp.667-674, 2012 (Released:2012-11-30)
参考文献数
31
被引用文献数
7 27

In order to elucidate the mechanism behind the decrease in the brittle-to-ductile transition (BDT) temperature with the addition of Ni, impact tests and tensile tests were performed at various test temperatures from 130K to 320K with Ni added ultra-low carbon steels. The dependence of absorbed impact energy on temperature and the Ni content indicates that the BDT temperature was decreased with the increasing Ni content, which suggests that the dislocation mobility at low temperatures was increased with the Ni content. The yield stress which is also influenced by the dislocation mobility was decreased at low temperatures while it was increased at room temperature with the Ni content. The values of the activation volume and the effective stress were measured at several temperatures, and then the dependence of the activation energy for dislocation gliding on Ni content was obtained by extrapolating the relation between temperature and the multiplication of the activation volume and the effective stress to 0K. The activation energy was found to decrease with the increasing Ni content, which suggests that the dislocation mobility was increased with the addition of Ni. Discrete dislocation dynamics simulation was also performed in order to calculate the dependence of fracture toughness on temperature and the Ni content, and it was clarified that the BDT temperature is decreased by increasing dislocation mobility.