著者

大島 龍司 山中 博 細見 暁

出版者

THE CARBON SOCIETY OF JAPAN

雑誌

炭素 (ISSN:03715345)

巻号頁・発行日

vol.2001, no.197, pp.88-91, 2001-05-15 (Released:2010-06-28)

参考文献数

5

被引用文献数

1 1

---

Suh-micron diamond powder was heat-treated and its machining pert ormance wax tested in the texturing process or fixed disk blanks. Comparison indicated a significant increase of up to some 30% in stock rein al. as well as a reduction of 5% in surlacc roughness over the corresponding diamond as untreated. Such improvement can be related to the et lect s of an incrased friability and thus in number or edges available I or the stock removal process. Scratch marks, on the other hand. were essentially eliminated as a result of the deposition of non-diamond carbon on the surfaces of diamond particles, so much as to leave only edge projection tips uncvoered.

著者

細見 暁

出版者

日本高圧力学会

雑誌

高圧力の科学と技術 (ISSN:0917639X)

巻号頁・発行日

vol.1, no.2, pp.143-146, 1992

被引用文献数

1

---

Very soon after their production was started, Komatsu Diamond Co. recieved, in June 1963, a letter from GE warning of possible infringement on their registered patent rights. This was the kickoff of a years long series of law suits between the two parties. Upon the registration of their “belt” apparatus patent in 1964, GE lodged, unsuccessfully, an application for a provisional court order to prohibit Komatsu's use of the brand-new apparatuses. The definitive proceedings began in late 1965, and legal inspectors came to the plant for the first time in 1966. The point of dispute was based on the difference in interpretation of the function of, particularly, the die lined with the ceramic sleeve.