著者

志鷹 拓哉 村島 基之 梅原 徳次 月山 陽介 新田 勇 上坂 裕之 鄧 興瑞

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.854, pp.17-00252-17-00252, 2017 (Released:2017-10-25)

参考文献数

8

被引用文献数

1

---

This paper addresses a novel lightweight and low starting torque bearing with looped carbon fiber brush (LCFB). LCFB simulates bristle of living being. Moreover, the static friction coefficient is nearly equal to the kinetic friction coefficient. By applying LCFB to a slide bearings, where a shaft is supported by multiple LCFBs, it is realized low starting torque bearings as well as lightness compared to conventional ball bearings. In this paper, we manufacture prototype LCFB slide bearings. With the bearings, we compare friction torque between LCFB slide bearings, slide bearings and deep groove ball bearings. As results, the ratio of starting torque to regular torque of LCFB slide bearing is from 0.93 to 1.07 which is smaller than that of the slide bearing. When micro-spline shaft is used as a mating material of LCFB slide bearing, the torque reduces because of decrease of real contact area between LCFB and mating materials. In addition, since LCFB utilize elastic deformation of fibers, LCFB slide bearings are not endurable in heavy radial load as high as load rating of ball bearing. Therefore, we define the load capacity of LCFB slide bearing from buckling load of a carbon fiber bundle to avoid overload state. We propose the load capacity as a design guideline of LCFB slide bearings.

著者

大山 慎太郎 梅原 徳次 上坂 裕之 鄧 興瑞 村島 基之 堀江 茂 松山 洋介

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.849, pp.16-00378-16-00378, 2017 (Released:2017-05-25)

参考文献数

13

被引用文献数

1

---

This paper describes about the effect of drill surface texturing on height of back burr in titanium alloy drilling process with solid lubricating sheet. Titanium alloy is difficult to conduct drilling because titanium alloy is hard and ductile material. And the workers cannot use plenty of liquid coolant for preventing the productivity decline when the work places are above their heads in production fields. Therefore drills are exchanged frequently even though the cost increases. In this study, we measured the cutting force by a loadcell to know the effect of drill surface texturing and solid lubricating sheet on drilling process of work pieces made of Ti-6Al-4V. As the results, drill with rough textured rake surface showed high burr height in exit of Ti-6Al-4V. On the other hand, drill with rough textured flank surface showed low burr height only if drilling with solid lubricating sheet. Moreover, drill with the specific texturing on flank surface by wire electric discharge machining showed low burr height.