著者
野口 駿雄 吉村 長蔵
出版者
一般社団法人 表面技術協会
雑誌
表面技術 (ISSN:09151869)
巻号頁・発行日
vol.40, no.4, pp.584-589, 1989-04-01 (Released:2009-10-30)
参考文献数
4

Specimens were electrolyzed by AC with various current waveform (sine wave, square wave and saw-tooth wave) and frequencies (10∼kHz) in NH4OH-NH4F system bath and NaOH-H2O2 system bath at a current density of 2A/dm2 for 30min, at 20°C.The use of a 10Hz square waveform resulted in a formation of a thicker film (5∼6μm) in both the NH4OH-NH4F and NaOH-H2O2 system baths. In the former case (NH4OH-NH4F system bath), film thickness decreased at frequencies above about 200Hz, reaching about 1∼2μm at frequencies above 1kHz. In the latter case (NaOH-H2O2 system bath), film thickness decreased according to increase of frequency, and it was about 0.5∼1μm in thickness at high frequency more than about 500Hz.The films anodized in the NaOH-H2O2 system bath with square current waveform was much rougher than those fromed using with sine or saw-tooth waveforms and larger pores were observed by microscope.Many large pores were observed in the coatings formed at high frequency and those formed in NaOH-H2O2 system bath had larger pores than those fromed in NH4OH-NH4F system bath.