著者
小原 哲郎 大八木 重治 高藤 亮一 蔡 品
出版者
一般社団法人 日本機械学会
雑誌
日本機械学会論文集 B編 (ISSN:03875016)
巻号頁・発行日
vol.67, no.659, pp.1680-1686, 2001-07-25 (Released:2008-03-28)
参考文献数
14

Experiments are carried out to investigate behavior of shock wave diffraction from a safety-engineering point of view. Because, once the shock wave is released into an ambience, high pressure and negative pressure lasting for relatively long period have possibility to cause serious damages against human bodies as well as general buildings. Therefore, it should be one of the most significant subjects to attenuate the shock wave efficiently within a short distance from the source. In this report, a cavity is installed at an open end of a shock tube and flow-fields behind diffracted shock wave are visualized using schlieren photography. In addition, piezo-electric pressure transducer is flush mounted on the surface of reflector, which is installed at test section, and pressure histories are recorded with wide frequency response. Lastly, numerical simulation using the TVD finite difference scheme is performed to compare with the experimental results. As a result, (i) the pressure histories on the reflector coincides well between the numerical and experimental results, (ii) flow-fields behind the shock wave are clarified, (iii) maximum pressure behind reflected shock wave can be attenuated by installing several cavities inside the open end of the shock tube.
著者
高藤 亮一 山中 昭央 小原 哲郎 蔡 品 大八木 重治
出版者
一般社団法人 日本機械学会
雑誌
日本機械学会論文集 B編 (ISSN:03875016)
巻号頁・発行日
vol.65, no.639, pp.3602-3607, 1999-11-25 (Released:2008-03-28)
参考文献数
12
被引用文献数
2 2

As is well known when a shock wave is emitted from an open end of a tube, an expansion wave and a vortex ring are generated behind the shock wave. Furthermore, a contact surface, slip line and these wave interactions may cause considerably complicate flow-fields. In this study, shock waves of Mach number 1.3, 1.6 and 2.2 are produced utilizing diaphragm-less shock tube of 50 mm diameter and c. a. 10 m total length, and the flow-fields are visualized with an aid of schlieren optical techniques. A cylindrical reflector is installed at test section and stagnation pressure behind reflected shock wave is measured with wide frequency response. A numerical analysis is also carried out to investigate these flow-fields using Predictor-Corrector TVD finite difference scheme. As a result, (i) the contour of diffracted shock wave is well coincided between experimental and numerical results, (ii) pressure histories behind reflected shock wave are clarified, (iii) an empirical formula is obtained between Mach number, non-dimensional distance from the open end of the tube and non-dimensional pressure just behind reflected shock wave.