著者

金子 康智 渡邉 敏生 前田 茂稔 鷲尾 宰司

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.855, pp.17-00184-17-00184, 2017 (Released:2017-11-25)

参考文献数

22

被引用文献数

3

---

Although bladed disks of turbomachinery are nominally designed to be cyclically symmetric (tuned system), the vibration characteristics of all blades on a disk are slightly different due to the manufacturing tolerance, the deviation of the material property, the wear during operation, and so on. These small variations break the cyclic symmetry, and split the eigenvalue pairs. The actual bladed disks with the small variations are referred to a mistuned system. Many researchers have studied mistuning, and main conclusions are while mistuning has an undesirable effect on the forced response, it has a beneficial (stabilizing) effect on the blade flutter (the self-excited vibration). Although such mistuning phenomena of bladed disks have been studied since 1980s, almost all studies focused on the amplification factor of the displacement response, and few studies researched the amplification factor of the vibratory stress response. Therefore, in the previous paper, authors studied the amplification factor expressed by the vibratory stress for the lower modes of the bladed disk, using the simple assumption. In this study, the mistuning effect expressed by the vibratory stress for the lower and higher modes are examined, using the reduced order model without any assumptions. First, formulation for evaluating the mistuning effect expressed by the vibratory stress is derived, using the reduced order model SNM (Subset of Nominal Modes). Second, the frequency response analysis of the mistuned simple bladed disk consisting of flat plates is carried out systematically. Finally, comparing the amplification factor of the displacement response with that of the vibratory stress response including the synthesized stress (Mises stress and the principal stress), mistuning phenomena expressed by the vibratory stress are clarified.