著者

Eiichi Goto Tatsuaki Tagami Koki Ogawa Tetsuya Ozeki

出版者

The Pharmaceutical Society of Japan

雑誌

Biological and Pharmaceutical Bulletin (ISSN:09186158)

巻号頁・発行日

vol.46, no.10, pp.1461-1467, 2023-10-01 (Released:2023-10-01)

参考文献数

34

---

Since three-dimensional (3D)-printed tablets were approved by the United States Food and Drug Administration (FDA), 3D printing technology has garnered increasing interest for the fabrication of medical and pharmaceutical devices. With various dosing devices being designed for manufacture by 3D printing, 3D-printed ophthalmic formulations to release drugs have been one such target of investigation. In the current study, 3D-printed contact lenses designed for the controlled release of the antibiotic azithromycin were produced by vat photopolymerization, and the effect of the printer ink composition and a second curing process was investigated. The azithromycin-loaded contact lenses were composed of the cross-linking reagent polyethylene glycol diacrylate (PEGDA), PEG 400 as a solvent, a photoinitiator, and azithromycin. The 3D-printed contact lenses were fabricated successfully, and formulations with lower PEGDA concentrations produced thicker lenses. The mechanical strength of the PEGDA-based contact lenses was dependent on the amount of PEGDA and was improved by a second curing process. Drug release from 3D-printed contact lenses was reduced in the samples with a second curing process. The azithromycin-loaded contact lenses exhibited antimicrobial effects in vitro for both Gram-positive and -negative bacteria. These results suggest that 3D-printed contact lenses containing antibiotics are an effective model for treating eye infections by controlling drug release.