著者

橋本 翔 小俣 弘樹 松永 久生

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.852, pp.16-00584-16-00584, 2017 (Released:2017-08-25)

参考文献数

19

---

It has been shown that rolling contact fatigue (RCF) test using specimen having a small drilled hole is a useful method for evaluating the effect of small defect on flaking strength of steels. In this study, RCF tests of rolling bearings having a small drilled hole were carried out. The flaking failure was considered as a problem of shear-mode fatigue crack emanating from the small defect. As a first step to quantify the crack-growth threshold on the basis of fracture mechanics, mode II stress intensity factor range, ΔKII, of a ring-shaped crack emanated around the edge of a drilled hole under the passing of a rolling element was analyzed by using finite element method. And then, the obtained values were correlated with the ΔKII values of penny-shaped cracks in an infinite body under uniform shear through the intermediary of a correlation factor, fdrill. The stress intensity factor of the ring-shaped crack was uniformly correlated with that of the penny-shaped crack by the single factor fdrill irrespective of hole diameter, d, depth of hole edge, h’, and maximum contact pressure, qmax, within the ranges: d = 0.05 ~ 0.2 mm, h’ = 0.05 ~ 0.345 mm and qmax = 2.0 ~ 3.0 GPa. The obtained results will be applied for the quantification of RCF test results shown in the subsequent paper.