著者

平戸 崇博 醍醐 市朗 松野 泰也 足立 芳寛

出版者

社団法人日本鉄鋼協会

雑誌

鐵と鋼 : 日本鐡鋼協會々誌 (ISSN:00211575)

巻号頁・発行日

vol.95, no.1, pp.96-101, 2009-01-01

被引用文献数

2 16

---

Recently, prices of natural resources have rapidly risen, so recovery of materials from the end-of-life products as secondary resources is of great interest. However, it is generally a challenging task to estimate the in-use stock of materials, especially in developing countries, because of lack of data. In this paper, two approaches, a top-down approach and a bottom-up approach, were adopted for estimating the in-use steel stock in end uses. A top-down approach uses time-series data of consumption and trade of materials and product lifetime data, whereas a bot-tom-up approach uses the numbers of units of a specified product in a designated area and its material intensities. In this paper, the steel stock in Japan divided into six end uses was estimated by the top-down approach. The steel in-use stock in Japan was estimated as approximately 1,000Tg in 2005. Steel stock in automobiles in 2005 was estimated as 105Tg by the bottom-up approach and compared with that estimated as 125Tg by the top-down approach. In addition, applying the bottom-up approach, steel stock used in automobiles in U.S. was estimated and compared with that obtained by the previous research using a top-down approach. Steel stock used in automobiles in 2000 in U.S. was estimated as 480-870Tg by the top-down approach and 754-767Tg by the bottom-up approach. Both approaches have some uncertainties in the parameters used in the estimation. Therefore, complementary use of the two approaches is helpful to estimate in-use stock of materials.