著者

永田 員也 真田 和昭

出版者

合成樹脂工業協会

雑誌

ネットワークポリマー (ISSN:13420577)

巻号頁・発行日

vol.36, no.6, pp.299-308, 2015-11-10 (Released:2016-01-07)

参考文献数

24

被引用文献数

1

---

フィラーの利用分野は多岐わたり,技術体系も複雑であることから,本稿ではトリックスポリマーをゴムや熱硬化性樹脂などの架ポリマーに焦点を当て,コンポジットの材料設計にいてフィラーの視点から詳しく紹介したい。

著者

進藤 裕英 高橋 知貴 堀口 勝三 小堀 智之 真田 和昭

出版者

一般社団法人 溶接学会

雑誌

溶接学会論文集 (ISSN:02884771)

巻号頁・発行日

vol.15, no.2, pp.370-375, 1997-05-05 (Released:2009-06-12)

参考文献数

10

被引用文献数

2 1

---

JJ1 type austenitic stainless steel is emerging as the preferred structural material for superconducting magnet casings to operate at liquid helium temperature (4K). In order to evaluate the cryogenic fracture toughness and the temperature rise of tangsten inertgas (TIG) weld in 200 mm thick forged JJ1 type austenitic stainless steel plate for fusion reactor magnets of the next generation, elastic-plastic fracture toughness (JIC) tests were performed with 1T compact tension specimens at 4K. Testing was conducted in accordance with ASTM standards E813-87 for determining JIC using the unloading compliance technique to monitor crack growth. Au/0.07% Fe -Chromel thermocouples were used to measure the temperature rise near the crack tip. The effects of specimen location and nitrogen content on JIC are examined. Specimens were subjected to scanning electron microscopy (SEM) after fracture testing. The effect of inclusion content on the elastic-plastic fracture toughness parameters (JQ, JIC) is also discussed using optical microscopy and energy dispersive X-ray spectrometer (EDX).