著者

中嶋 大智 相田 健一郎 秋山 裕喜 瀧上 唯夫 富岡 隆弘 西山 幸夫 田中 隆之 宮本 岳史 今岡 憲彦

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.854, pp.17-00078, 2017 (Released:2017-10-25)

参考文献数

21

被引用文献数

3

---

It is pointed out that the yaw dampers, which are often installed in between carbody and bogie frame of a high-speed railway vehicle, have such unfavorable points that the damping force is generated not only in the yawing direction but also in other direction. As a result the damping force is generated also to the longitudinal or pitching vibration of a bogie, and the excitation force acts in the longitudinal direction of the carbody resulting in the increase of the carbody vibration of the longitudinal or vertical direction. In this research, to enable the reduction of the excitation of the carbody vibration while maintaining the original function of yaw dampers to prevent bogie hunting motion, a new mounting structure of yaw dampers on railway vehicles has been developed. The new mounting structure enables to reduce the excitation force transmitted from a bogie frame to a carbody through yaw dampers. In this paper, the effect of yaw dampers on the carbody vertical vibration is firstly shown based on the results of an excitation test of a full-scale vehicle, then the outline of the new mounting structure for yaw dampers and the design and manufacture of the prototype device are presented. The vehicle dynamics model based on multi body dynamics was constructed and the suppression effect of the yaw damper force generated to movement in the direction other than the yawing direction of a bogie was verified by the numerical simulation. Moreover, the prototype device was installed on a full-scale test vehicle and a bogie hunting motion test was carried out to verify the running stability.

著者

瀧上 唯夫 秋山 裕喜 朝比奈 峰之 山本 克也

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.84, no.861, pp.17-00531-17-00531, 2018 (Released:2018-05-25)

参考文献数

13

被引用文献数

1

---

It is one of the important issues to investigate the vibration behavior of railway bogies, since the vibration of the bogies may result in loosening bolts which fix the parts to the bogie frames or/and fatigue fracture of the parts themselves. A technique for predicting the vibration of bogie parts is proposed by which the acceleration power spectral densities (PSDs) at evaluated points are predicted with the use of frequency response functions (FRFs) between the axle boxes and the evaluated points, together with the use of measured accelerations of axle boxes. Stationary excitation tests are conducted to identify the FRFs, and the axle boxes or rails were hit with impulse hammers to excite the bogies. Alternatively, the new approach without the stationary tests is also proposed in this study. In this case, the FRFs are identified with the accelerations acquired in the preliminary running tests in car depots. The proposed technique is applied to the vibration prediction of the bogies for several types of railway vehicles including electric cars and a diesel car, and the differences or ratio between the predicted and actually measured PSDs are evaluated. It is confirmed that the preliminary running tests are preferable to stationary excitation tests for improving the prediction accuracy. It is also verified that the prediction error can be reduced in the case where not only the vertical but the lateral and longitudinal accelerations of axle boxes are considered as the excitation inputs under the conditions that the principal component regression is applied to identify the FRFs.