著者

室屋 祐二 元木 聡宏 島ノ江 憲剛 春田 幸典 寺岡 靖剛 山添 昇

出版者

公益社団法人日本セラミックス協会

雑誌

日本セラミックス協会学術論文誌 : Nippon Seramikkusu Kyokai gakujutsu ronbunshi (ISSN:18821022)

巻号頁・発行日

vol.114, no.1326, pp.189-194, 2006-02-01

参考文献数

18

被引用文献数

1

---

A ceramic coating slurry was designed, which suspended or dissolved ceramic components (silica, titania, alumina and kaolinite) and glass-forming components (alkali silicates and soda ash) in water. SiO_2-Al_2O_3-TiO_2 based composite films (about 100μm thick) were deposited on a steel plate by coating the slurry with a brush, followed by drying and calcination. The ceramic coatings obtained under proper conditions were found to exhibit excellent stability over a wide range of temperature. As evaluated by copper electrodeposition method, through-holes were present in the coatings calcined at 700℃ or below, while they were eliminated completely after calcination at 1100℃ in N_2. Vickers hardness of the coatings increased with increasing calcination temperature, while adhesive strength went through a sharp maximum at 800℃.

著者

市川 麻理子 元木 聡 柴田 昌明

出版者

The Institute of Electrical Engineers of Japan

雑誌

電気学会論文誌. D, 産業応用部門誌 = The transactions of the Institute of Electrical Engineers of Japan. D, A publication of Industry Applications Society (ISSN:09136339)

巻号頁・発行日

vol.126, no.6, pp.726-731, 2006-06-01

参考文献数

8

被引用文献数

1 3

---

This paper proposes a visual servo control method for exploring motion of eye-in-hand robot to recognize a three-dimensional object. The CCD camera attached at the manipulator tip captures the images of the target object, and then the robot varies its own posture with referring the position transitions in the images of the feature points on the object. Our approach for optimal motion is based on the strategy in which the position estimation precision of the feature points in the captured images gets improved when the feature points move widely, and the optimal robot motion provides the widest transitions of the feature points per unit robot motion, so that the robot should be controlled to purse such motion. In the proposed method, the primary feature point is made located at the center of the image, while the other points are moved for achieving the optimal transition in the image. In addition, this paper describes the way to reduce calculation effort for the proposed method. The numerical and physical experiments have been executed with use of 3-DOF planar manipulator. The validity of our approach is confirmed in the several experimental results.