著者

佐藤 運海 竹ノ内 敏一 原 宏 山崎 隆夫 若林 信一

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 C編 (ISSN:03875024)

巻号頁・発行日

vol.71, no.710, pp.3074-3080, 2005-10-25 (Released:2011-03-04)

参考文献数

7

被引用文献数

8 8

---

This paper describes development of end milling of carbon steel by electrolyzed reduced water of dilute sodium chloride solution, instead of conventional cutting with cutting fluid which is not environmentally consciousness. First, experimental equipments were built with a machining center, cutting fluid supply system made from the bath pump, temperature sensor and temperature recorder etc., and end milling processing of carbon steel was performed using electrolyzed reduced water of dilute sodium chloride solution and conventional cutting fluid respectively. Next, measured surface roughness, evaluated surface deterioration layer, temperature change of work piece and wear state of end milling. As the results of all evaluations above-mentioned, there is no difference between the end milling process using electrolyzed reduced water and that of conventional using cutting fluid. It is supposed electrolyzed reduced water instead of cutting fluid is environmentally consciousness process.