著者

森田 良 稲田 文夫 内山 雄太 梅沢 修一 石橋 雅裕 舩木 達也

出版者

一般社団法人 日本機械学会

雑誌

日本機械学会論文集 (ISSN:21879761)

巻号頁・発行日

vol.83, no.849, pp.16-00526-16-00526, 2017 (Released:2017-05-25)

参考文献数

15

被引用文献数

3

---

In industrial fields, as the steam is commonly utilized for heat supply, drying process and so on, it is important to be aware of the steam flow rate in the view point of energy management. However, the steam utilized in the factory is usually wet steam condition. Though it is well known that the wetness affects the flowmeter reading, it is difficult to clarify the effects of the wetness in the steam flow quantitatively in actual plants and factories, and thus far, there has been no established method for estimating the error caused by the wetness of steam flow. In this paper, the difference of ultrasonic flowmeter reading due to wetness of the wet steam flow was clarified experimentally. Ultrasonic flowmeter reading in the wet steam flow was compared with Coriolis flow meter installed after heat exchanger in the steam apparatus. As a result, we clarified the flow rate difference of those two flowmeters was increased with increasing wetness, and the ultrasonic flowmeter reading was almost the same as the value of steam phase flow rate in the wet steam flow. We also proposed the correction method of the ultrasonic flowmeter reading by using density correction in the flow rate formula of the ultrasonic flowmeter. And finally, we clarified the uncertainty of the measured flowrates and their differences were less than 1.0%.