著者
澤畠 公則 堀 雅寛 永田 稔 榎本 裕治
出版者
一般社団法人 電気学会
雑誌
電気学会論文誌D(産業応用部門誌) (ISSN:09136339)
巻号頁・発行日
vol.141, no.10, pp.771-777, 2021-10-01 (Released:2021-10-01)
参考文献数
10

Downsizing of motors by achieving a high power density is required to meet the emission regulations of each country. In this study, we developed a permanent magnet synchronous motor (PMSM) with high space factor, which enables the motor to be downsized. This PMSM applies the welding-less rectangular coil to shorten the axial motor length. The developed PMSM was verified by elemental and measurement tests. The test results confirmed that (i) the local heating of the welding-less coil was 4.5K and (ii) the torque and coil temperature of the developed PMSM reached their design values.
著者
榎本 裕治 鈴木 啓介 沖田 誠治 江藤 昂平 片山 英二
出版者
一般社団法人 電気学会
雑誌
電気学会論文誌D(産業応用部門誌) (ISSN:09136339)
巻号頁・発行日
vol.141, no.5, pp.423-430, 2021-05-01 (Released:2021-05-01)
参考文献数
25
被引用文献数
6

We have been studying the application of amorphous metals, which have a significantly lower loss than electrical steel sheets, to motors. Thus far, we have studied simple-shaped iron cores that can be machined only by shearing for radial motors. However, it is considered that the loss can be further reduced if the iron core is entirely made of amorphous metal. Here in this report, we report the results of a trial evaluation of a motor in which an amorphous metal is punched using a press die to form a stator core.
著者
中津川 潤之介 岩路 善尚 榎本 裕治
出版者
一般社団法人 電気学会
雑誌
電気学会論文誌D(産業応用部門誌) (ISSN:09136339)
巻号頁・発行日
vol.136, no.4, pp.263-269, 2016-04-01 (Released:2016-04-01)
参考文献数
23

We have developed novel mathematical models of d-axis and q-axis magnetic fluxes ϕd and ϕq for permanent magnet synchronous motors (PMSMs). The models can be used to approximate magnetic characteristics using simple fractional equations with id and iq as variables. They include eight constants, and some of them represent the degree of magnetic saturation and cross-coupling. However, the magnetic characteristics are varied with the temperature rise in PMSMs, which are dependent on the load torque and motor speed. In this paper, the characteristics of the eight constants that vary with the motor temperature and the residual flux density Br are shown. Further, we propose to extend the mathematical models by considering the temperature and Br variation.
著者
榎本 裕治 床井 博洋 今川 尊雄 鈴木 利文 小俣 剛 相馬 憲一
出版者
The Japan Society of Applied Electromagnetics and Mechanics
雑誌
日本AEM学会誌 (ISSN:09194452)
巻号頁・発行日
vol.24, no.3, pp.258-263, 2016 (Released:2016-12-21)
参考文献数
13
被引用文献数
10

This paper presents the development of high efficiency (IE5-class) industrial motor with an amorphous core for large capacity applications. Interest in saving energy increases on a global scale, and the high efficiency of the motor attracts attention. As for the motor of the field of industry, legal regulation to IEC standard is promoted in each country. We developed the magnetic characteristic evaluation technology and highly precise analysis design technique in the motor to reduce a loss more from the IE4 efficiency class. We found core structure to reduce the loss of the amorphous metal core, and the trial motor was able to achieve an efficiency class of IE5 by applying it.