著者

石崎 彰 田中 丈志 高崎 一彦 西方 正司 渡邉 勝之 片桐 淳夫

出版者

一般社団法人 電気学会

雑誌

電気学会論文誌D(産業応用部門誌) (ISSN:09136339)

巻号頁・発行日

vol.113, no.10, pp.1192-1199, 1993-10-20 (Released:2008-12-19)

参考文献数

4

被引用文献数

14

---

It is well known that the direct drive systems not to use the reduction gears with the clearane and backlash are required for the highly precise position control, whose motor must have high torque at very low speed. The authors have developed a new motor for this purpose and named PM vernier motor.In this paper, it is explained at first what is PM vernier motor, the construction and principle, and then the theory able to calculate the torque and how to control its speed are described. It is also shown that the calculated values of torque were agreed well with the experimental results.

著者

石崎 彰 田中 丈志 高崎 一彦 西方 正司 渡邉 勝之 片桐 淳夫

出版者

The Institute of Electrical Engineers of Japan

雑誌

電気学会論文誌D(産業応用部門誌) (ISSN:09136339)

巻号頁・発行日

vol.113, no.10, pp.1192-1199, 1993

被引用文献数

19 14

---

It is well known that the direct drive systems not to use the reduction gears with the clearane and backlash are required for the highly precise position control, whose motor must have high torque at very low speed. The authors have developed a new motor for this purpose and named PM vernier motor.<br>In this paper, it is explained at first what is PM vernier motor, the construction and principle, and then the theory able to calculate the torque and how to control its speed are described. It is also shown that the calculated values of torque were agreed well with the experimental results.

著者

石崎 彰 柴田 幸也 渡邉 勝之 斎藤 和夫

出版者

The Institute of Electrical Engineers of Japan

雑誌

電気学会論文誌D(産業応用部門誌) (ISSN:09136339)

巻号頁・発行日

vol.111, no.9, pp.785-793, 1991

被引用文献数

20 11

---

The application of the direct drive system is increasing in the field of robot and factory automation because of controllability with high accuracy. However, it requires the motor high torque at low speed.<br>Although the vernier motor, presented by C. H. Lee in 1963, could produce the reluctance torque in low speed, it involved many problems to be solved. In this paper, the authors have studied the reluctance torque of vernier motor using the finite element field analysis. As the increase of rotor slot number is effective to produce high torque, in our model there are not only winding slots but also small slots on the stator teeth surfaces and the rotor slots are provided in the periphery of the core more than the total number of stator slots by the pole number. The calculated torques have agreed very well with the experimental results.<br>A prominent feature of the control scheme is to control the armature current phase based on the detected rotor slot position, so there is no problem such as pull-in or pull-out in the vernier motor of C. H. Lee. And then the instantaneous torque is controlled by the amplitude of armature current. The experimental results on both the speed control and the position control were also shown in the paper.