- 著者
- 世木 選 新井 智貴 福島 槙一郎 細井 厚志 藤田 雄三 武田 一朗 川田 宏之
- 出版者
- 一般社団法人 日本機械学会
- 雑誌
- 日本機械学会論文集 (ISSN:21879761)
- 巻号頁・発行日
- vol.83, no.851, pp.16-00571-16-00571, 2017 (Released:2017-07-25)
- 参考文献数
- 15
- 被引用文献数
- 1
Fatigue properties of the thick carbon fiber reinforced plastic (CFRP) laminates with toughened interlaminar layers in the out-of-plane direction (Z direction) and in the in-plane transverse direction (T direction) were evaluated experimentally. Spool specimens were machined from the thick mother plates which were laminated prepregs of T800S/3900-2B unidirectionally. The specimens were attached to metal tabs to apply loads in the thickness direction of the specimen. The tensile strengths in Z and T direction were measured by static tensile tests and S-N curves were obtained by fatigue tests at a stress ratio of R=0.1. As the results, the tensile strength in Z direction was 24% lower than that in T direction. Fatigue strength in Z direction at 106 cycles was also 25% lower than that in T direction. It was observed using a digital microscope that the fracture occurred in intralaminar layers in both static tensile tests and fatigue tests in Z direction. The thermal residual stress which was generated during the fabrication process and the stress distribution by mechanical loadings in spool specimens were calculated by finite element analysis. The calculated results showed that compressive residual stress applied in intralaminar layers in T direction by restraining the thermal deformation. It is found that the static tensile and fatigue properties in Z direction were almost the same as those in T direction by evaluating with the stresses applied in the nearest intralaminar layer to the minimum cross-section in the spool specimen.