著者
海老原 大樹 正田 英介
出版者
一般社団法人 電気学会
雑誌
電気学会誌 (ISSN:13405551)
巻号頁・発行日
vol.115, no.7, pp.420-423, 1995-06-20 (Released:2008-04-17)
参考文献数
10
被引用文献数
1 1
著者
久保 興輔 宮武 昌史 首藤 克彦 正田 英介
出版者
The Japan Institute of Electronics Packaging
雑誌
エレクトロニクス実装学会誌 (ISSN:13439677)
巻号頁・発行日
vol.4, no.3, pp.237-240, 2001-05-01 (Released:2010-03-18)
参考文献数
4

For the electronic equipment, various printed circuit boards are used. Recently, the electronic equipment is getting miniaturized, and insulation reliability of the printed circuit boards becomes the important problem. In this environment, paper phenol base printed circuit boards are produced a lot and mainly used for the consumer article, so that we examined the ionic-migration of paper phenol base printed circuit boards. Generally, the resistance value of the paper phenol base printed circuit board is lowered with continual rapid-dropping and recovering of the resistance value in the high-humidity/temperature test for ionic-migration when it passed about 1500 hours. However, when it passed after 300 hours, the rapid changes of the resistance value by the ionic-migration were observed in our test, and it was observed that the bridging is done between some electrodes of the printed circuit boards.
著者
林屋 均 大崎 博之 正田 英介
出版者
The Institute of Electrical Engineers of Japan
雑誌
電気学会論文誌. D, 産業応用部門誌 = The transactions of the Institute of Electrical Engineers of Japan. D, A publication of Industry Applications Society (ISSN:09136339)
巻号頁・発行日
vol.120, no.6, pp.928-933, 2000-07-01
被引用文献数
6 1

To improve the quality of products in a steel making process, the realization of a non-contacting conveyance of a steel plate has been expected. To make the total system simple, we proposed a combined lift and propulsion system by transverse flux linear induction motors. By feeding the DC biased AC to the transverse flux linear induction motor, it is possible to realize an efficient combined lift and propulsion system with a simple structure. After showing the peculiarities of the system, conveyance experiments of a steel plate are carried out. In these experiments, the equivalent mass estimation method in which the levitation mass is estimated from the gap error is applied and the effect of the method is also shown.
著者
坂田 博 宮本 宏彰 杉本 健二 菊池 和彦 磯村 滋宏 正田 英介
出版者
The Institute of Electrical Engineers of Japan
雑誌
電気学会論文誌D(産業応用部門誌) (ISSN:09136339)
巻号頁・発行日
vol.113, no.6, pp.728-734, 1993
被引用文献数
1

Recent development in power electronics has made power semiconductor device larger and complicated, and device simulation is necessary to predict their characteristics. From the fundamental equations of semiconductor device, potential distribution and carrier concentrations can be solved using the finite element method. In this study, we make formulation for one dimensional analysis of a gate turn off thyristor (GTO) and simulate switching characteristics in order to know the effects of snubber circuit. In conclusion snubber condensor is necessary to suppress spike voltage, but increases the turn off loss of GTO.