文献一覧: The Surface Finishing Society of Japan (出版者)

1 0 0 0 OA 強誘電体ゲートトランジスタの動作原理と開発動向

著者: 徳光永輔石原宏
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.51, no.7, pp.669-675, 2000-07-01 (Released:2009-10-30)
参考文献数: 17

2020-10-28 22:48:32
1 + 5 Twitter

1 0 0 0 OA チタン建材とその表面処理

著者: 佐藤廣士
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.43, no.11, pp.1014-1019, 1992-11-01 (Released:2009-10-30)
参考文献数: 15
被引用文献数: 3 4

2020-08-17 12:34:42
1 + 0 Twitter

1 0 0 0 OA 光触媒の固定化法

著者: 吉本哲夫
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.50, no.3, pp.242-246, 1999-03-01 (Released:2009-10-30)
参考文献数: 15
被引用文献数: 7 4

2020-08-07 04:49:00
1 はてなブックマーク

1 0 0 0 OA アルミニウムのアルカリ性化学研磨液における浴組成と光沢度, 表面構造との関係について

著者: 新藤恵美吉田明松本誠臣
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.51, no.6, pp.633-639, 2000-06-01 (Released:2009-10-30)
参考文献数: 8

Chemical polishing solutions for aluminum based on mixtures of phosphoric and nitric acid cause air pollution with hazardous gaseous emissions, such as NOx, during the chemical polishing process, and cause water pollution due to the effluent of wastewater that contains phosphates and nitrates. Hence, the authors attempted to polish aluminum in an alkaline solution containing sodium hydroxide as an alkaline agent and sodium persulfate as an oxidizing agent. In this process, exceptionally bright surfaces of aluminum were obtained; that is, the brightness of the surface polished in the alkaline solution was comparable with that of the surface polished in an acid chemical polishing solution. The composition of the alkaline solution that had the least polishing effect had a concentration of sodium hydroxide in a range of 0.5 to 1.5% by weight for pure aluminum and a range of 1.0 to 2.0% by weight for commercially pure aluminum, while the concentration of sodium persulfate was 35% by weight. At with a high magnification on a scanning electron microscope (SEM), network patterns were observed over the entire polished surface of the aluminum polished in the alkaline solution and that in the acid chemical polishing solution. On the surface of the commercially pure aluminum polished in the alkaline solution, very small projections were observed by SEM, that were identified by electron probe microanalysis (EPMA) as insoluble phases that included foreign elements such as Fe and Si in the aluminum. On the other hand, on the surface of the aluminum polished in the acid chemical polishing solution, very small pits were observed, formed by dissolution of the phases in the acid solution. Also, use of x-ray photoelectron spectroscopy (XPS) and fourier transform infrared spectroscopy (FT-IR) indicated that the oxide films formed on the surface of the aluminum polished in the alkaline solution were thicker and contained a larger amount of hydroxyl radicals than those on the surface polished in the acid chemical solution.

2020-04-13 14:00:59
1 + 0 Twitter

1 0 0 0 OA フォトリソグラフィ (1)

著者: 駒野博司
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.46, no.9, pp.778-783, 1995-09-01 (Released:2009-10-30)
参考文献数: 19
被引用文献数: 1

2020-02-04 20:08:00
1 + 1 Wikipedia

1 0 0 0 OA ガラスと無電解ニッケルめっきの密着性

著者: 堀田慎一鈴木佳司渡辺幹男本間英夫
出版者: The Surface Finishing Society of Japan
雑誌: 表面技術 (ISSN:09151869)
巻号頁・発行日: vol.44, no.10, pp.831-835, 1993-10-01 (Released:2009-10-30)
参考文献数: 9
被引用文献数: 3 3

Various factors influencing the adhesion between glass and electroless nickel plated films were investigated. In terms of the film, it was found that the use of glycine as a complexing agent resulted in films that exhibited good adhesion. Adhesive strength also increased at lower pH and lower plating bath temperature. In terms of pretreatment, etching was important to improving adhesion. Adhesive strength was greatest when the glass was first etched with sodium hydroxide, next etched with hydrofluoric acid and then treated with methylate. Adhesion was also increased by decreasing the level of dissolved oxygen in the catalyzing treatment solution and plating bath.