著者
吉井 二郎 藤本 浩平 山口 達也
出版者
高知県立森林技術センター
雑誌
高知県立森林技術センター研究報告 (ISSN:13486004)
巻号頁・発行日
no.30, pp.45-54, 2005-03

高知県東部のスギ・ヒノキ高齢林の立地環境、林分構造、林床植生の調査を行った。立地環境は、土壌型でスギ・ヒノキともBD型ないしBD(d)型がBB型やrBA型に比べて成長が良い傾向がみられた。林分構造は、スギ・ヒノキとも胸高直径・樹高階分布にバラツキがみられ、特にスギの胸高直径のバラツキが非常に大きかった。また、スギでは後生枝、ヒノキでは枯れ枝が付いているものが多くみられた。林床植生は、高齢林と壮齢林では「種の豊富さ」に差はみられないが、「種多様度指数」「均等度指数」で違いがみられ、高齢林は壮齢林に比べて豊かな植生を構成していた。
著者
山口 達也 恒川 隆明 澤野 弘明 石井 成郎 鈴木 裕利
雑誌
第79回全国大会講演論文集
巻号頁・発行日
vol.2017, no.1, pp.389-390, 2017-03-16

手話学習において一般的に書籍や映像が用いられる.映像学習の場合,書籍よりも手話動作を理解しやすいが,動作撮影の手間や映像出演に対する抵抗感により,手軽に制作することが難しい.そこで筆者らはWikiのように誰でも情報の共有が可能であり,CGキャラクタを利用して手話映像を生成する,手話CG Wikiの開発を行っている.手話CG Wikiではボタン操作によりCGキャラクタの動作を制御し,全体と手先の映像を提供する.本稿では手話CG Wikiのユーザインタフェースの評価を行う.評価実験では手話経験者に手話CG Wikiを操作して頂き,操作性や手話CGの完成度について考察する.
著者
延本 尚也 岡野 生也 篠山 潤一 山本 直樹 安田 孝司 代田 琴子 安尾 仁志 相見 真吾 橋本 奈実 太田 徹 深津 陽子 鳥井 千瑛 田村 晃司 山口 達也 陳 隆明
出版者
日本理学療法士学会
雑誌
理学療法学 (ISSN:02893770)
巻号頁・発行日
pp.11247, (Released:2017-05-01)
参考文献数
27

【目的】本研究の目的は在宅脊髄損傷者の退院後の褥瘡発生の有無を調査し,在宅脊髄損傷者の褥瘡発生危険因子を明らかにすることである。【方法】1996 年1 月~2005 年12 月までの10 年間に,当院を退院した脊髄損傷者310 名を対象に,郵送法による自記式アンケートを実施した。アンケート回答結果とカルテ診療録の情報を基に,後方視的に検討した。【結果】アンケート回収率は51.0%であり,約半数の対象者は退院後に褥瘡を経験していた。損傷の程度,入院中の褥瘡既往の有無,調査時の介助量,介助量の変化,外出頻度,自家用車の運転の有無が有意な因子として認められた。【結論】在宅脊髄損傷者において,完全損傷であること,入院中の褥瘡の既往があること,介助量が多いこと,活動性が低いことが褥瘡発生危険因子となることが明らかとなった。一方で,同居人の存在や在宅サービス利用の有無については褥瘡予防に有効に作用していない可能性が示唆された。
著者
山口 達也 恒川 隆明 澤野 弘明 石井 成郎 鈴木 裕利
雑誌
第79回全国大会講演論文集
巻号頁・発行日
vol.2017, no.1, pp.389-390, 2017-03-16

手話学習において一般的に書籍や映像が用いられる.映像学習の場合,書籍よりも手話動作を理解しやすいが,動作撮影の手間や映像出演に対する抵抗感により,手軽に制作することが難しい.そこで筆者らはWikiのように誰でも情報の共有が可能であり,CGキャラクタを利用して手話映像を生成する,手話CG Wikiの開発を行っている.手話CG Wikiではボタン操作によりCGキャラクタの動作を制御し,全体と手先の映像を提供する.本稿では手話CG Wikiのユーザインタフェースの評価を行う.評価実験では手話経験者に手話CG Wikiを操作して頂き,操作性や手話CGの完成度について考察する.
著者
畠山 貴充 平野 幸助 中村 雄太 藤澤 彰宏 土屋 貴司 山口 達也 千田 有一 吉村 達也
出版者
一般社団法人 日本機械学会
雑誌
日本機械学会論文集 (ISSN:21879761)
巻号頁・発行日
vol.83, no.851, pp.16-00531-16-00531, 2017 (Released:2017-07-25)
参考文献数
21

In the present paper, development of an automatic spinach harvester is discussed. Our research group has been developing a prototype harvester and many filed tests have been successfully executed. The field test results show that spinach can be picked up automatically without being grasped after their roots being cut at specified position in soil. The harvester equips two degrees of freedom control units, such as the arm length control unit and the arm angle control unit, for controlling a root-cutting blade which follows the specified path under the ground. In the present paper, modeling and control design for the arm length control is discussed. First, a control design model is developed by several system identification techniques. Next, an I-PD controller is designed by the robust control design procedure. Control performance is verified by numerical simulations and field tests.
著者
廣岡 知 山口 達也 渡部 利文 山本 順也 城代 邦宏 保田 尚俊 塚田 和彦 小池 克明 朝倉 俊弘
出版者
一般社団法人 資源・素材学会
雑誌
Journal of MMIJ (ISSN:18816118)
巻号頁・発行日
vol.133, no.5, pp.98-106, 2017-05-01 (Released:2017-05-31)
参考文献数
12

In addition to hydrological characterization of water-sealed type underground rock caverns, their mechanical stability is constantly monitored by measuring several properties, such as earthquake-induced vibration, strain, and tilt. Among them, tilt measurement is the most accurate monitoring method for rock deformation because of the tiltmeter's high resolution of 10-9 rad, which enables the detection of minute deformations caused by earth tide, rock responses to earthquake, change in atmospheric pressure, and artificial disturbance by operation. This study aimed to correctly extract these responses from long-term tilt data measured by a high precision tiltmeter at the Kushikino station and clarify the mechanism of tilt change as a result of deformation of rock mass. Tilt changes due to a small change in the gas phase pressure at the top of the rock cavern, approximately 10 kPa pressure fluctuation, were analyzed and discussed. The gradient response due to the gas pressure change was extracted from the measurement data by BAYTAP-G, and its magnitude was identified as 2 to 8 nrad, which was almost the same tilt response magnitude observed at an issuance of stored crude oil. This tilt response to the increase in tank gas pressure was numerically confirmed to originate from minute elastic deformation of rock masses, by using finite element method. Because fluctuation of the gas phase pressure can be continuously monitored, the effectiveness of tilt measurement was proved as a minute strain sensor for deformation of the water-sealed type underground rock cavern.