著者
孙 强 佐々木 久郎 菅井 裕一 ンゲレ ロナルド
出版者
一般社団法人 資源・素材学会
雑誌
Journal of MMIJ (ISSN:18816118)
巻号頁・発行日
vol.137, no.1, pp.17-23, 2021-01-31 (Released:2021-01-29)
参考文献数
25

In this study, pressure response at A monitoring well in early stage of CO2 geological storage were predicted against pressure build-up at CO2 injector after starting CO2 injection into a deep saline aquifer to design the monitoring well distance from the injector and resolution or sensitivity of a pressure transmitter installed in the monitoring well. The numerical simulations on pressure distributions and expanding CO2 plume front were carried out using a reservoir simulator, CMG-STARS, for the aquifer (10 km in radius, 50m in height) with open boundary under 1,000 m from the ground or seabed level. The ratio of pressure response at the monitoring well against the pressure build-up at the injector have been presented for various monitoring locations (500 to 5,000 m from a injector) and homogeneous and heterogeneous models of horizontal permeability distribution in the aquifer (Base Model and Model 1, 2 & 3) and CO2 injection patters during 100 days (Scheme 1, 2 & 3). It has been presented from the numerical simulation results that the monitoring well radial distance from the injector is recommended to be 2,000 to 4,000 m or less than 1000 m when the resolution or sensitivity of the pressure transmitter is 1kPa or 10kPa, respectively.
著者
熊本 和宏 國友 美信 岸本 章宏 岡本 克文 倉満 晶子 宇田 哲也
出版者
一般社団法人 資源・素材学会
雑誌
Journal of MMIJ (ISSN:18816118)
巻号頁・発行日
vol.137, no.1, pp.10-16, 2021-01-31 (Released:2021-01-29)
参考文献数
31

A new Ti smelting process via. Bi–Ti alloy is proposed. This process comprises reduction of TiCl4 to Bi–10 mol%Ti alloy by Bi–Mg alloy, precipitation of Ti-rich compound from the alloy, and vacuum distillation. In this study, we investigated the precipitation and distillation processes. In the precipitation process, the Bi–10 mol%Ti liquid alloy is cooled from 900 ℃ to 500 ℃ to precipitate Bi9Ti8 in the liquid alloy. The Bi9Ti8 is recovered by a two-step separation method: recovery of mixture of Bi9Ti8 and Bi and further removal of Bi by centrifugal filtration. We demonstrated the recovery of mixture. As the results, Ti concentration in the mixture was 31 mol%, and the Ti yield was about 45 %. Because the remained liquid alloy after the recovery contains a large amount of Bi9Ti8, it is required to reuse the remained alloy in the precipitation process. Assuming the reuse of remained alloy, the material flow of the process was designed based on the experimental results. The centrifugal filtration of the mixture of Bi9Ti8 and Bi was also carried out at 500 ℃. By the centrifugal filtration at 50 G, alloys with a size of 1.5 mm were obtained, and the Ti concentration in the alloys was increased from 31 mol% to 40 mol%. Vacuum distillation of alloy powder and ingot was demonstrated. The distillation rate was enhanced when using the powder than when using alloy ingot as a starting material.
著者
岡田 夏男 前川 陽平 大和田 済熙 芳賀 一寿 柴山 敦 川村 洋平
出版者
一般社団法人 資源・素材学会
雑誌
Journal of MMIJ (ISSN:18816118)
巻号頁・発行日
vol.137, no.1, pp.1-9, 2021-01-31 (Released:2021-01-29)
参考文献数
10
被引用文献数
3

Currently, there have been issues concerning the depletion and scarcity of mineral resources. This is mostly due to the excavation of high grade minerals having already occurred years and years ago, hence forcing the mining industry to opt for the production and optimization of lower grade minerals. This however brings about a plethora of problems, many of which economic, stemming from the purification of those low grade minerals in various stages required for mineral processing. In order to reduce costs and aid in the optimization of the mining stream, this study, introduces an automatic mineral identification system which combines the predictive abilities of deep learning with the excellent resolution of hyperspectral imaging, for pre-stage of mineral processing. These technologies were used to identify and classify high grade arsenic (As) bearing minerals from their low grade mineral counterparts non-destructively. Most of this ability to perform such tasks comes from the highly versatile machine learning model which employs deep learning as a means to classify minerals for mineral processing. Experimental results supported this statement as the model was able to achieve an over 90% accuracy in the prediction of As-bearing minerals, hence, one could conclude that this system has the potential to be employed in the mining industry as it achieves modern day system requirements such as high accuracy, speed, economic, userfriendly and automatic mineral identification.
著者
薗田 将樹 山本 昇伯 髙田 敦子 菊地 学 田宮 大介 遠藤 良二 伊藤 隆
出版者
一般社団法人 日本東洋医学会
雑誌
日本東洋医学雑誌 (ISSN:02874857)
巻号頁・発行日
vol.69, no.2, pp.155-160, 2018

<p>東洋医学的治療が有効であったうつ病の3症例を報告する。3症例とも同一職場(全17名)の職員。症例1は46 歳男性,勤続20年。主訴は抑うつ,不眠。症例2は28歳女性。勤続9年。主訴は嘔気,気分不良。症例3は41歳男性,勤続15年。主訴は焦燥感,不眠,抑うつ。3症例に対して抑肝散および抑肝散加陳皮半夏で加療し,症状の改善がみられた。今回,処方選択において3症例が同一の職場環境であることを考慮した。抑肝散には母子同服という服用法が伝えられている。また,精神神経分野にて情動伝染(Emotional Contagion)という情動の共有システムがHoffman(1984)により提唱されている。総合的に考えると母子同服は情動伝染を考慮した経験的治療法であり、同一職場のような同じコミュニティ内でも応用可能と考察した。本症例のように,同一職場内の情動伝染を考慮した職場内同服は有用である可能性がある。</p>
著者
矢崎 克己
出版者
日本鱗翅学会
雑誌
やどりが (ISSN:0513417X)
巻号頁・発行日
vol.2000, no.186, pp.30-31, 2000-09-30 (Released:2017-08-19)
参考文献数
2
著者
石津 憲一郎 安保 英勇
出版者
一般社団法人 日本教育心理学会
雑誌
教育心理学研究 (ISSN:00215015)
巻号頁・発行日
vol.56, no.1, pp.23-31, 2008-03-30 (Released:2013-02-19)
参考文献数
29
被引用文献数
27 14

臨床場面では過剰適応は非適応的とされているが, 実証的な過剰適応研究は数が少ない。本研究では過剰適応の概念を理論的に整理し, その構造を検討することを第1の目的とした。続いて, 従来言われてきたように過剰適応が個人にとって非適応的に作用するのかを実証的に検討することを第2の目的とした。中学生を対象にした調査の結果, 過剰適応は個人の性格特性からなる内的側面と, 他者志向的で適応方略とみなせる外的側面から構成されることが示された。また, 過剰適応と学校適応感, ストレス反応との関連を検討した結果, 過剰適応の内的側面は学校適応感およびストレス反応にネガティブな影響を与えていたが, 適応方略として捉えられる外的側面は学校適応感を支える一方で, ストレス反応にも正の影響を与えることが示された。本研究の結果, 従来言われてきたこととは異なり, 必ずしも過剰適応的であることが非適応的とはみなすことができないことが示された。しかし, 他者志向的な適応方略で支えられる適応感の影にはストレスの存在が想定され, そのストレスが将来の不適応を予測する可能性について考察を行った。
著者
北村 祐介 柴原 尚希 稲葉 敦
出版者
日本LCA学会
雑誌
日本LCA学会誌 (ISSN:18802761)
巻号頁・発行日
vol.17, no.1, pp.8-15, 2021 (Released:2021-01-27)
参考文献数
37
被引用文献数
1

国連世界観光機関(UNWTO)は、多くの人が移動する観光は地球温暖化などの気候変動に影響する重要な問題であると警鐘を鳴らしている。観光とライフサイクルアセスメント(LCA)研究では、旅行パッケージ、移動、宿泊、飲食、産業に起因する温室効果ガス(GHG)をカーボンフットプリント(CFP)で評価している。一方、近年社会的に注目されている持続可能な開発目標(SDGs)の目標およびターゲットには、明確に観光を対象としている項目がある。また、日本でも日本版持続可能な観光ガイドライン(JSTS-D)が発行された。現在、新型コロナウィルス感染症(COVID-19)による深刻な影響が続いており、日本の産業は観光業を含めて大きな転換を迫られているが、同時に、COVID-19 からのリカバリーを起点として、持続可能な観光への大きな転換のチャンスを迎えていると考えることができる。観光に関連する事業者、業界団体、研究組織、大学などが一体となって持続可能性に向けた取り組みを実施することが必要とされている。