著者
杉原 健児
出版者
一般社団法人日本建築学会
雑誌
建築雑誌 (ISSN:00038555)
巻号頁・発行日
vol.102, no.1262, pp.115-116, 1987-08-20
著者
松下石人 著
出版者
正文館
巻号頁・発行日
1936
著者
文部省 著
出版者
[文部省]
巻号頁・発行日
1912
著者
牧野 行雄 塩原 匡貴 村松 久史 川口 貞男 山内 恭 田中 正之 小川 利紘 増谷 浩二 森井 正夫 Yukio Makino Masataka Shiobara Hisafumi Muramatsu Sadao Kawaguchi Takashi Yamanouchi Masayuki Tanaka Toshihiro Ogawa Koji Masutani Masao Morii
雑誌
南極資料 (ISSN:00857289)
巻号頁・発行日
vol.87, pp.1-22, 1985-12

南極中層大気の総合観測(Antarctic Middle Atmosphere Program)の一環として, 南極昭和基地において1983年3月24日から1984年12月29日まで(第24次および第25次南極地域観測隊)太陽光の赤外分光測定による大気微量成分(N_2O, CH_4,CFCl_3,CF_2Cl_2,HNO_3)の観測を行った。使用した分光計の分解能は最高0.1(cm)^<-1>まで設定可能であるが, 観測時間の長さやS/N比を考慮して0.8(cm)^<-1>で通年観測を行った。延べ111日間に計487個のスペクトルを得たが, これらは最終的に磁気テープに記録し大型電子計算機で処理する。測定されたスプクトルのS/N比から, CFCl_3(850(cm)^<-1>), N_2O(2576(cm)^<-1>), CH_4(6004(cm)^<-1>) のカラム密度は, それぞれ±40,±2,±6%の測定誤差を有することが見積もられる。特に1000(cm)^<-1>域のより精密な測定のために, 今後, 高感度検知器(MCTなど)の安定な使用による観測が望まれる。As part of the Japanese Antarctic Middle Atmosphere Program (Antarctic MAP), columnar amounts of atmospheric minor constituents such as N_2O, CH_4,CFCl_3,CF_2Cl_2 and HNO_3 were determined from measurements of infrared solar spectra for the period 24 March 1983-29 December 1984 at Syowa Station, Antarctica (69°00′S, 39°35′E). A Fourier-transform-infrared spectrometer was used to measure the solar spectra. The highest apodized resolution of the spectrometer is 0.1(cm)^<-1> (full width at half-maximum), but the resolution of 0.8(cm)^<-1> was adopted in routine operation because of an economy of data processing time and of better signal to noise (S/N) ratio. The accuracy of measurements is estimated from S/N ratios of the obtained spectra; typical errors of measured abundances were ±40,±2 and ±6% for CFCl_3 (at 850(cm)^<-1>), N_2O (at 2576(cm)^<-1>) and CH_4 (at 6004(cm)^<-1>), respectively. A MCT detector (cooled at 77 K) is desirable to attain higher resolutions (&acd;0.1(cm)^<-1>) and larger S/N ratios.
著者
小野 徹郎 石田 交広 下野 耕一
出版者
日本建築学会
雑誌
日本建築学会構造系論文集 (ISSN:13404202)
巻号頁・発行日
vol.60, no.469, pp.117-125, 1995
参考文献数
18
被引用文献数
6 4

Recently, more rational and economical design method has been required to the steel structural design. As one of the solutions, "Standard for Limit State Design of Steel Structures (draft)", based on the theory of reliability, was published in 1990. However, regarding design of the bracing member, this draft standard adopted basically the conventional design method, because there were not enough data to make a new design method. To obtain the applicable data to limit state design, the present study aims elaslo-plastic behavior of a steel column or beam with the bracing member. This paper represents results of its numerical analysis. Furthermore, mechanical properties of the bracing member is examined in the three kinds limit state, which are "Buckling Limit State", "Full Plastic Limit State" and "Deformation Capacity Limit State".

1 0 0 0 OA 塔影

著者
河井酔茗 著
出版者
金尾文淵堂
巻号頁・発行日
1905

1 0 0 0 OA 家庭十二ケ月

出版者
啓成社
巻号頁・発行日
vol.3月の巻, 1910
著者
桃園野史 編
出版者
岡本仙助
巻号頁・発行日
1889
著者
小林 賢一 大鎌広 藤原 祥隆
出版者
一般社団法人情報処理学会
雑誌
情報処理学会研究報告ハイパフォーマンスコンピューティング(HPC)
巻号頁・発行日
vol.2000, no.23, pp.149-154, 2000-03-02
被引用文献数
2

メッセージプーリング方式のPCクラスタを用いた分散処理システム"Clop"における、プログラム開発を支援するためのリアルタイムログシステムについて論じている。PCクラスタにおけるプログラム開発では、全計算サーバのイベント(計算開始、データ送信等)の実時間上の正確な順序を知り、かつそのイベントの種類と時刻の記録(イベントログ)を得ることが必要となる。しかしながら、分散処理している複数計算機は時刻が一致しているとは限らない。よって、イベントログを正確な順序で得ることは困難である。本稿では、ユーザのプログラム実行中に、計算機間の時刻のずれを計測することで、イベントログの発生時刻を補正できることが示されている。This paper presents a real-time logging system to develop programs on "Clop". "Clop" is a distributed computing system of Message-Pooling for a PC cluster. For developing the programs on the PC cluster, it is required of obtaining the exact sequence of events(starting of computation, sending of the data, etc.) and recording event log that includes type and time-stamp of the occurred events. However, each clock of the computers on the PC cluster is not always equivalent to others. Therefore, it is difficult to obtain the event log with the exact sequence. It is shown to adjust the time-stamps in the event logs by the measuring offset of each of the computers during the execution of a user program.
著者
宋 祥甫 縣 和一 川満 芳信
出版者
日本作物学会
雑誌
日本作物學會紀事 (ISSN:00111848)
巻号頁・発行日
vol.59, no.1, pp.107-112, 1990-03-05
被引用文献数
4

水稲の子実生産は, 出穂期前に稈・葉鞘部に蓄積された非構造性炭水化物 (NSC) と出穂後の葉身光合成による同化産物とによって決まることから, 本報ではそれぞれの指標となる茎葉中のNSC%と葉身窒素濃度 (N%) の動態に注目して, F_1ライスの多収性を検討した。F_1ライスの葉身中のNSC%は普通稲品種に比べて大差はなかったが, 稈・葉鞘部では顕著に高かった。各品種とも出穂後NSC%は急減したが, 普通稲品種では登熟期後半に再び高まった。これに対してF_1ライスは登熟末期まで減少を続け, その減少率も大きかった (第1図)。出穂期から登熟末期にかけてのNSC%の減少と稈・葉鞘部から子実への乾物の転流分との間には高い正の相関々係が認められた (第3図)。また, 玄米収量との間にも高い正の相関々係がみられた (第4図)。これらの結果は, 子実への転流の主体はNSCであること, 稈・葉鞘部のNSC%は玄米収量と密接な関係にあることを示し, F_1ライスの多収性は高いNSC%に負うところが大きいことが示唆された。各品種とも葉身のN%は稈・葉鞘部に比べて高く, 生育段階が進むにつれて減少した。F_1ライスの N%は葉身, 稈・葉鞘部とも普通稲に比べて低く, 減少割合も小さかった (第5図)。葉身のN%と玄米収量との間には, F_1ライスを除いた場合, 両者間に有意な正の相関々係が認められた (第6図)。以上の結果から, F_1ライスの子実生産は普通稲品種に比べて, 出穂期前に稈・葉鞘部に蓄積された炭水化物に依存する割合が大きいことが明らかになった。
著者
土山雅人
雑誌
日臨生理会誌
巻号頁・発行日
vol.20, 1990
被引用文献数
1