著者

S. Gopalakrishnan foreword Raju Kalidos

出版者

Sharada Pub. House

巻号頁・発行日

2005

著者

島谷弘幸編

出版者

思文閣出版

巻号頁・発行日

2014

著者

中嶋修著

出版者

彩流社

巻号頁・発行日

2012

著者

町田恵一著

出版者

印刷学会出版部

巻号頁・発行日

2017

著者

[東洲斎写楽ほか画] 山口桂三郎責任編集

出版者

ぎょうせい

巻号頁・発行日

1991

著者

喜多川歌麿 [画] 下村良之介 [ほか] 著

出版者

新潮社

巻号頁・発行日

1991

著者

内田千鶴子著

出版者

三一書房

巻号頁・発行日

1993

著者

浅田 孝紀 Asada Takaki

出版者

人文科教育学会

雑誌

人文科教育研究 = Journal of Language Teaching (ISSN:09131434)

巻号頁・発行日

vol.19, pp.101-110, 1992-08-01

著者

Yoji Arakawa Xiaolin Li Mitsuru Ebihara Engin Meriç Izavel Tansel Simau Bargu Hayrettin Koral Kuniteru Matsumaru

出版者

GEOCHEMICAL SOCIETY OF JAPAN

雑誌

GEOCHEMICAL JOURNAL (ISSN:00167002)

巻号頁・発行日

vol.37, no.6, pp.681-693, 2003-12-20 (Released:2008-04-08)

参考文献数

42

被引用文献数

2 3

---

Some element concentrations were measured and element profiles were made for the Cretaceous-Tertiary (K-T) boundary layers in Medetli, Gölpazari, northwestern Turkey. In Medetli region, gray-colored medium to coarse grained sandstone (layer A) is overlain by yellow-colored fine-grained sandstone with intercalated thin goethite-rich layers (layer B). White colored limestone (layer C) overlies on the layer B. The layer A is latest Cretaceous and layer C is early Paleocene, and in layer B (28–37 cm in thickness) fossils are absent, and is regarded as a K-T transitional layer. In several goethite-rich layers, siderophile elements such as Fe, Cr, Ni, Co, and chalcophile element, such as As, Sb, and Zn, are enriched, and have maximum in succession from layer A to C. The enrichment of these elements are common features in most of K-T boundary sediments of the world. However, Ir concentration is relatively low (0.05–0.10 ppb) in the goethite-rich layers. The analyzed Ir concentration is slightly elevated (0.24 ppb) only in the top part of layer A. Iridium may have been diluted during sedimentation and diagenesis. The actual K-T boundary may be situated between the top of layer A and the bottom of layer B. The section from the top part of layer A to layer B is assumed to have been formed during the K-T and its successive events.

著者

山本 俊一 宮崎 正之助 岡田 和夫 館野 功 高木 忠信 古田 昭一 呉 大順 佐藤 富蔵

出版者

日本細菌学会

雑誌

日本細菌学雑誌 (ISSN:00214930)

巻号頁・発行日

vol.20, no.8, pp.534-539, 1965-08-25 (Released:2009-02-19)

参考文献数

18

---

The authors tried to elucidate the therapeutic effect of hyperbaric oxygenation on the experimental infection of the anaerobic pathogens, using mice and rabbits as experimental animals.1) Cl. novyi was rather resistant to the action of oxygen at high pressure. It was presumably due to the spore formed.2) In order to prevent the death of the mice inoculated with Cl. novyi, the animals should be repeatedly exposed to the oxygen at moderate pressure. The excessive oxygenation was toxic to the animals, rendering them less resistant to the infection.3) Toxin of Cl. novyi was not decomposed by hyperbaric oxygenation. It has also no effect on the detoxication process of the organisms or on the toxin neutralization in vitro and in vivo.4) In case of gas gangrene hyperbaric oxygenation therapy should be combined with antitoxin treatment, as the former suppresses the growth of pathogens and the latter neutralizes toxin produced.5) In the experiment with with rabbit, repeated hyperbaric oxygenation was proved markedly effective to the infection with Cl. norvyi, but less effective to Cl. tetani.In the latter case, the excessive oxygenation was unfavorable to the infected animals.

著者

上田 早苗

出版者

東洋史研究會

雑誌

東洋史研究 (ISSN:03869059)

巻号頁・発行日

vol.28, no.4, pp.19-41, 1970-03

著者

桐村 喬

出版者

皇學館大学

雑誌

皇學館大学紀要 = Bulletin of Kogakkan University (ISSN:18836984)

巻号頁・発行日

vol.57, pp.196-175, 2019-03-15

著者

増田 雪也

出版者

一般社団法人 品質工学会

雑誌

品質工学 (ISSN:2189633X)

巻号頁・発行日

vol.9, no.6, pp.40-46, 2001-12-01 (Released:2016-08-31)

参考文献数

1

---

Electro-polishing is a process having a merit of being able to obtain a smooth surface. In the process, it is necessary to adjust the processing conditions depending on the shape. But few reports have been published on the effects of processing conditions, which are mostly determined by experience. In this study, an electro-polishing process was optimized for austenitic stainless steel using the Quality Engineering approach. From the results it was clarified that the factors including polishing voltage, anode surface, anode surface diameter and polishing solution flaw significantly affect SN ratio and sensitivity. Under the optimum condition, it became possible to continue working without being affected by the deterioration of the polishing solution.

著者

鈴木 徳三

出版者

大妻女子大学

雑誌

大妻女子大学紀要 文系 (ISSN:09167692)

巻号頁・発行日

no.24, pp.p1-4,図3p, 1992-03

著者

北川 圭子 大垣 直明

出版者

日本建築学会

雑誌

日本建築学会計画系論文集 (ISSN:13404210)

巻号頁・発行日

vol.69, no.576, pp.171-177, 2004-02-28 (Released:2017-02-09)

参考文献数

17

被引用文献数

1

---

A dining kitchen is the Japanese English named by the Japan Housing Corporation in 1955, and is the fundamental housing style of postwar Japan. The purpose of this study is to make clear forming process of a dining kitchen. After the defeat of the Second World War, when Japanese some architects had the subject of a minimum house, they proposed "Wohn Kuche" as a model. "Wohn Kuche" was a housing style for a minimum house in Germany after the First World War. On the other hand, architects proposed three new life-styles. They were "separation of a meal room and a bedroom", "taking a meal on a chair", and "democratization of a kitchen." It is thought that the dining kitchen was materialized by two proposals, "Wohn Kuche" and the three life-styles.

出版者

高速道路調査会

巻号頁・発行日

vol.22, no.9, 1979-09

著者

本城和彦 著

出版者

鹿島研究所出版会

巻号頁・発行日

1965

著者

小島 颯 高田 勝悟 Kesevan Veloo 仲村 将司 中條 拓伯

雑誌

組込みシステムシンポジウム2019論文集

巻号頁・発行日

no.2019, pp.5-8, 2019-08-29

著者

堀内 正浩

出版者

新興医学出版社

雑誌

Modern physician (ISSN:09137963)

巻号頁・発行日

vol.37, no.6, pp.550-553, 2017-06

著者

仲尾 保志

出版者

日本運動器科学会

雑誌

運動器リハビリテーション = The journal of musculoskeletal medicine : 日本運動器科学会誌 (ISSN:21878420)

巻号頁・発行日

vol.26, no.1, pp.15-20, 2015