著者
織田 隆三
出版者
社団法人 全日本鍼灸学会
雑誌
全日本鍼灸学会雑誌 (ISSN:02859955)
巻号頁・発行日
vol.45, no.2, pp.129-134, 1995-06-01 (Released:2011-05-30)
参考文献数
2
被引用文献数
1

高級モグサを製造するとき最後の精製を行う装置が唐箕である。モグサ用唐箕は農業用唐箕とは異った構造の特殊な装置である。主要部分は, 高速度で回転する羽根車, 羽根車を取り囲む大きな円筒状の竹の箕及びこれを納める木製の箱型構造体から出来ている。粗製モグサを唐箕に入れ, 羽根車を1分間70~120回の高速で回転すると不純物は簀の間隙から外へ排出され, 簀の内部には高級モグサが残る。通常は先ず一番目の唐箕で粉状の不純物を大体除き, 二番目の唐箕で精製を仕上げる二段階方式をとる。所要時間は3~8時間であるが, 条件によっては更に増減がある。
著者
酒井 誠 藤井 正明
出版者
化学同人
雑誌
化学 (ISSN:04511964)
巻号頁・発行日
vol.60, no.11, pp.34-38, 2005-11
被引用文献数
1
著者
志智 莉永 井坂 行男
出版者
大阪教育大学
雑誌
大阪教育大学紀要. 第4部門, 教育科学 = Memoirs of Osaka Kyoiku University (ISSN:03893472)
巻号頁・発行日
vol.65, no.2, pp.19-26, 2017-02

本研究では,聴覚障害児に対する音楽科指導の現状や今後の在り方を検討するために,聴覚特別支援学校小学部の音楽科指導に関する質問紙調査を実施した。第一次調査の結果,音楽科の4つの活動のうち音楽づくりの活動の実施率の低さ,指導の際の音の聴取における困難及び指導方法等での困難が多く挙げられた。また,活動毎の内容に関連する効果が児童に認められること等も明らかになった。第二次調査の結果,拡大楽譜や映像といった視覚的な教材の使用が,児童の理解や関心を促せること,理解度や授業に取り組む態度を重視する個人評価が実施されていることが分かった。聴覚障害児に対する音楽科指導の一層の充実には(1)ICT機器の充実度の違い,(2)教員間での情報交流の場の設定,(3)4つの活動毎の実施率のばらつき,という3点が課題と考えられた。
著者
片江 祐二 島田 佳宏 松本 康二郎 近藤 秀臣 森 俊陽 西田 茂喜 安田 学 花桐 武志
出版者
西日本整形・災害外科学会
雑誌
整形外科と災害外科 (ISSN:00371033)
巻号頁・発行日
vol.67, no.1, pp.189-190, 2018-03-25 (Released:2018-05-21)
参考文献数
5

【目的】当科を初診した転移性骨腫瘍症例の特徴と必要な検査について検討した.【対象と方法】2012年からの5年間に新小倉病院で転移性骨腫瘍と診断され,カルテベースで後方視的に調査しえた132例のうち,悪性腫瘍の既往がなく整形外科受診時に転移性骨腫瘍が明らかになった9例(全例男性,60-88歳[中央値76歳])を対象にした.検討項目は,①初診時の主訴,②罹患骨,③腫瘍原発巣,④原発腫瘍検索方法,⑤原発腫瘍同定率である.【結果】①初診時の主訴は腰痛・背部痛が7例,②罹患骨は脊椎が8例で最も多かった.③腫瘍原発巣は前立腺癌4例,肺癌3例であった.④⑤原発腫瘍検索は,体幹部CT検査が9例で,その同定率は77.8%であった.【考察】整形外科を初診する70歳以上の男性では転移性骨腫瘍の可能性を念頭におく必要があり,原発腫瘍の検索には体幹部CT検査(造影含む)が簡便かつ非侵襲的で考慮すべき検査と考えた.
著者
平出 文久
出版者
耳鼻と臨床会
雑誌
耳鼻と臨床 (ISSN:04477227)
巻号頁・発行日
vol.35, no.6, pp.1022-1027, 1989-11-20 (Released:2013-05-10)
参考文献数
26

突発難聴を主訴として来院し, 初診時に突発性難聴と診断されたが, その後の精査により肝細胞癌の側頭骨転移癌によることが判明した1例を報告した. 患者は57歳の男性で, 1987年6月右突発難聴, 耳閉塞感が発現し, 近くの病院で突発性難聴と診断され, 副腎皮質ホルモン療法を受けたが症状は改善されなかつた. 耳X線検査で右内耳道近辺の不整像が観察され, 聴神経腫瘍などの脳腫瘍が疑われた. 同年8月精査を希望し当科を受診, CTおよびMRI検査により右側頭骨底から後面にかけて大きな腫瘍塊が認められた. 右骨部外耳道底に出現した小さな腫瘍の生検によりこれらの腫瘍塊は肝細胞癌の転移癌であることがわかつた. この症例ではほかに同側の顔面神経麻痺, 反回神経麻痺が認められたが, 突発難聴とともに多発性脳神経症状が発現した場合には側頭骨転移癌の可能性も考慮すべきである.
著者
Iwao KOIZUMI Yoshihiko SUZUKI J. J. KANEKO
出版者
Center for Academic Publications Japan
雑誌
Journal of Nutritional Science and Vitaminology (ISSN:03014800)
巻号頁・発行日
vol.37, no.6, pp.545-554, 1991 (Released:2009-04-28)
参考文献数
11
被引用文献数
11 13

The fatty acid composition of the intramuscular lipids of cattle, pigs and birds were determined relative to breed and feeding regime. The cattle included Yellow Cattle, Hereford and Japanese Black; pigs included Wild-boar, Touyuens and Yorkshires; the birds were Wild-birds, Jungle-fowl and broilers. The pen fed animals such as Japanese Black cattle and Yorkshire pigs had a higher amounts of oleic acid, palmitic acid and palmitoleic acid. On the other hand, wild or pasture fed animals such as the Herefords, Wild-boars and Touyuens had higher amounts of ω-3 fatty acids such as α-linolenic acid, icosapentaenoic acid and ω-6 fatty acids such as linoleic acid and arachidonic acid. Among Wild-fowl, open-yard fed birds or broilers, there was no difference in fatty acid composition. It is suggested the meat of pasture fed or wild fed animals such as Herefords, Yellow Cattle and Wild-boar is better for health than meat from pen fed animals.
著者
阪山 由衣子 加藤 孝憲 牧野 泰三 近藤 修 Yannick DESPLANQUES Philippe DUFRENOY
出版者
一般社団法人 日本機械学会
雑誌
日本機械学会論文集 (ISSN:21879761)
巻号頁・発行日
pp.16-00324, (Released:2017-04-05)
参考文献数
11
被引用文献数
2 1

Frictional heat is generated on the rubbing surface and various types of thermal localization occur during sliding contact in braking on disk and pad surfaces. Thermoelastic expansion affects the contact pressure distribution due to the frictional heat generation. The surface temperature is sometimes localized, and the thermal behavior causes surface damage. To evaluate this phenomenon, braking tests were conducted and the localized temperature on the disk surface was observed with an infrared camera. The localized temperature was found to correlate with frequency response for contact force variation. To investigate localized temperature on the disk surface, FEM analysis of the braking test was conducted. The FEM analysis method combined with contact analysis and heat transfer/thermal stress analysis was applied. Heat flux distributions were calculated by contact analysis in consideration of the frictional heating introducing the actual contact force and the friction coefficient variation. The disk surface temperature was then evaluated by the coupled heat transfer/thermal stress analysis using the heat flux distributions obtained from the results of contact analysis. The disk surface temperature obtained from FEM analysis almost coincided with that measured during the braking test. Moreover, the new method could greatly reduce the calculation time compared to the method using the contact analysis alone. Therefore, the proposed method is believed to be useful for evaluation of the rubbing surface temperature.
著者
横山 恵子
出版者
日本経営倫理学会
雑誌
日本経営倫理学会誌 (ISSN:13436627)
巻号頁・発行日
vol.7, pp.163-172, 2000-03-31 (Released:2017-07-28)

It is generally accepted that corporations should create not only economic value but also social value, which builds a symbiotic relationship between corporations and society. This study considers the idea of social value as both economic value and non-economic value (such as cultural and political value). What kind of management process is required to realize these in a manner that is well balanced for each stakeholder? Non-economic value in particular is based on quality of life and humanity, both of which are difficult to express as numerical value and tend to be sacrificed. In this paper I analyze the process of creating both non-economic and economic value by focusing on the stakeholder relationship. Normative theory has been the mainstream so far with regard to the social nature of corporations. Almost no empirical study has been carried out on social value and the management process. This study analyzes the process of creating social value in corporations using the case of The Body Shop International PLC and builds a "model for the process of creating social value in corporations". The constituents and key factors required for the model to function are indicated.